R32 Gtst Wrecking And Gtr Cams

[Dabro]

Hi All

Trying to get rid of the wreck taking up my garage. message me for what you want and ill help you if i can. Some things still available listed below.

Make offers on what you want.

Front bilstein shocks (hard, near new)

Lowered king springs

Removable steering wheel with boss kit.

RB20DET 5 speed with noisy input bearing (has been for 13,000 kms and not getting worse)

R32 Sedan RB25 auto diff head, tall ratio, good for that torquey 3ltr, non LSD

Rear lights, bumper, boot lid, spoiler, front guards, bonnet, both doors with windows. All factory metallic wine/red

Factory RB20 intercooler

front and rear windows

Various interior parts (ask)

Std rear shocks

R32 RB25 motor with flywheel and good clutch, clean runner but needs welsh plugs changed in block.

Car has L/H rear damage but is repairable for road or race, not written off, prepared to sell whole if anyone wants it. Has four stud hubs as I put the five stud GTST gear on my other car. Still rolling so can be put on a trailer no worries.

Also

R32 gtr cams and buckets (no shims)

R32 gtr std exhaust manifolds

Reasonable offers will be taken on everything

Prefer pickup or meet in Sydney campbelltown/bankstown areas

[Lemzki]

have you got both tension rods. "outer tie rod ends" with bushes to be specific. if so, how much?

[mitch_SR32]

Do you have the reo bar and if so what condition is it in and how much?

[Godzilla_400R]

Hi Have U Got R32 Low Beam Headlight Clips That Clips The BUlbs In Place And The Headlight Switch

[GTR DNA]

Mate,

How much for the tail lights? Also do you have a good condition Dash pad.

Regards

[Ryno]

PM Sent

[R32Abuser]

PM sent

[Dabro]

Mate,

How much for the tail lights? Also do you have a good condition Dash pad.

Regards

Will take 60 for the tailights. The dash is not bad but has a small buldge above the clove box in the normal spot also it is a bit heat shrunk and hard as well, edges raised around the vents etc, would be ok if yours is buggered.

[Dabro]

Hi Have U Got R32 Low Beam Headlight Clips That Clips The BUlbs In Place And The Headlight Switch

Sorry mate lights are gone

[Dabro]

Do you have the reo bar and if so what condition is it in and how much?

Yeah still got it, straight and uncut.

$70

[mitch_SR32]

How much to post/courier it to 0812 Leanyer, Northern Territory????

VERY INTERESTED!!

[R32Abuser]

I sent a PM but have got no reply so i guess ill post here

Im after the surround that goes around the Dash instrument cluster (speedo/tacho etc)...the one in the 32 which has the light switch/hazzards/radio/wipers control on it. Im after this with all switches. What is the condition of this part? Picture emailed to [email protected] or sms/call me on 0401 317 009

Cheers!

[Lemzki]

no reply yet about the tension rods..

[jtole3]

Lower control arm

Castor Rod

Swaybar mount

Tie Rod

Castor Rod Brackets Pair

Im in Brisbane South East

Rochedale South

Pm me I need these parts ASAP

[Dabro]

I sent a PM but have got no reply so i guess ill post here

Im after the surround that goes around the Dash instrument cluster (speedo/tacho etc)...the one in the 32 which has the light switch/hazzards/radio/wipers control on it. Im after this with all switches. What is the condition of this part? Picture emailed to [email protected] or sms/call me on 0401 317 009

Cheers!

Hi,

Sorry for the delay. The switchs are not all good. I have used the light switch in my other car. if youe still interested i will post a pic of the surround for you.

[Dabro]

no reply yet about the tension rods..

They are there but not sure about the bushings condition, will look tomorrow for you.

[Dabro]

How much to post/courier it to 0812 Leanyer, Northern Territory????

VERY INTERESTED!!

Not sure but could find out next week if you really want it. Probabaly going to cost more to post than to buy!!

[G3TFKD]

hey do you have the little surround that holds the gearboot on? what is the condition like if you do?

[mitch_SR32]

Not sure but could find out next week if you really want it. Probabaly going to cost more to post than to buy!!

I don't mind, but my brother lives in wollongong so I could probably arrange for him to pick it up from you for me and then he can send it later to save me some money. If thats easier for you let me know asap

[Lemzki]

They are there but not sure about the bushings condition, will look tomorrow for you.

as long as they're decent then ill take em