Jump to content
SAU Community

Recommended Posts

G'day all.

I have a set of R33 GTR rear seats for sale, they are perfect condition, i have had them professionally cleaned, there are no marks, no ciggie burns, basically a nice and clean set of rear seats. (not sure if there series 1 or 2)

I am selling them because i purchased  both front and rear set of seats and only used the front ones in my Stagea.

Price is $200 

Please p.m me.

Im located in botany and it is pick up only or i can meet you somewhere.

Pictures will be up either this afternoon or tomorrow.

Thank you.

Link to comment
https://www.sau.com.au/forums/topic/305503-fs-r33-gtr-rear-seats-syd/
Share on other sites

24012010003.jpg

24012010004.jpg

24012010005.jpg

Bumpies, now with pics and price drop to $180 i wont go less then this, if they don't sell i will keep them and make something out of them, allso found out that they are from a series two v-spec

Cheers.

mate i really dont have the time, if you can organise a courier to pick them up from my house i would be more then happy to.

Big price drop once again, 120, i need them gone this week, please don't bother making offers, this price is final and pretty damn ridiculous.

  • 2 weeks later...

final unbelievable drop half price 100 dollars, for the guys who have been sending me p.m's about postage im sorry i simply have no time to organise it, this is pick up only.

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...