Jump to content
SAU Community

Recommended Posts

Hi All,

I'm looking at buying "APEXi Auto Timer" for my R33 Series II. I'll be also buying the wiring harness for it and I want to be sure I don't need to hack anything apart once I have this harness. Where does the wiring harness plug into?

Im not confident with cutting wires and so forth so I just want to be sure before I buy it. Also is there anything else I need to be aware of? Is the factory alarm OK with the engine going and doors locked?

Thanks

Link to comment
https://www.sau.com.au/forums/topic/30664-apexi-auto-timer-wiring-question/
Share on other sites

Ok, I've found a good price a price too for the harness however perfectrun.com.au list it as "plug needs to be modified" also apexi-usa.com don't have a R33 GTST harness. Most places only have a GTR harness.

Does anyone have one of these workin in their GTST? Any ideas what needs to be modified on the wiring?

Factory alarm??? In my experience no alarm likes turbo timers, most will not arm with the ignition on. Is the turbo timer the pen style one? if this is the case you ned to splice into the computers wiring harness for the air fuel ratio meter to work. the english instructions are too hard to read due to poor resolution so use the japaneese instructions to view the pin layout of the ECU. :D hope this helps...

I got a response from Perfectrun.com.au and it all seems good, just need to modify the wiring harness plug so its fits the iginition plug on the r33.

Hi,

Connector part of the optional wiring harness needs to be cut slightly so the factory connector can be slide into it easily.

Regards,

Taki

Perfect Run

[email protected]

By pressing the left/right buttons you should be able to. Sounds like a loose contact wire or ground wire. Does the display ever loose power? Do the sensors all work OK? Do the A/F and 02 display values?

http://www.apexi-usa.com/productdocumentat...nstructions.pdf

and

http://www.apexi-usa.com/productdocumentat...s_autotimer.pdf

has anyone managed to wire it up to handbrake wire? where do you find wires for the handbrake?

hi Rianto, if you remove your ashtray and the 2 screws behind it, then pull out the panel around the gear shift, it makes it easier to get the cup holder out. then you will see a yellow wire on the hand brake assy, thats the one you need. :D

Thank's Danny...

In re: car alarms not happy with turbo timers, I got an alarm which unlocks the door on ignition off and locks the door on ignition on. What happens is when engine was turned off by the turbo timer, my door will unlock. So the car will be vulnerable for 30s until the alarm's auto arm feature kicks in. My plan is to disable this feature, so when engine is running with turbo timer, I can lock the car manually. When timer runs out and turn off engine, it will not unlock the doors. Car is still vulnerable for 30s but at least now the doors stay locked. 30s later the auto arm kicks in. I can even shorten the 30s auto arm period for extra security, like 15s but not very practical when you don't need turbo timer, as you'll need to rush collecting your things to get out before 15s runs out and auto arms your car.

hi Rianto, if you remove your ashtray and the 2 screws behind it, then pull out the panel around the gear shift, it makes it easier to get the cup holder out. then you will see a yellow wire on the hand brake assy, thats the one you need. :D
No it's none of those. It's Code Alarm :)

Oh well..... if it is a 2003 pro series Code alarm try this

1- keep door open

2- Turn key to IGNITION ON position

3- press and hold valet switch for 5 seconds (LED will glow constantly)

4- press buttons 1 & 2 of transmitter TWICE

5- LED will flash twice

6- once you have confirmed the LED has flashed twice

7- press button 2 of the transmitter to turn off ignition door lock feature

8- Siren will chirp twice to confirm feature is off

10 - turn off ignition and close door to exit learn routine

Hope this helps :D

paul, its all good mate, just sometimes doesnt keep it running when i remove the key...

should i re check all the connections

Did you hook the handbrake wire up? if the connection on this wire sees a bad earth then it will not allow the TT to operate. Some people just earth this wire

Auto trust, ill do that.. but the thing is, i havent installed the timer myself so where do u think that wire could be? is it straight of the TT pen thing or is there a lil black box where its all connected to.. ?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah everyone always seems to refer to them as S13 wheels however they came on R32 Skyline, A31 Cefiro, C33 Laurel etc., and also came polished diamond cut or painted depending on the model. Congrats on your GTS purchase! I'd personally leave it NA.
    • In this thing about this 100% renewal energy stuff I hear no one really talking about anything other than power and fuel really Power and fuel, whilst being a huge part of how we use the billion year old Dinosaur juices, are only 2, of the probably thousands of things that we need to use it for in the chemicals industries for making nearly everything we use nowadays I'm all for a clean planet, but if we want to continue to have all the day to day appliances and stuff that we rely on everyday we will still need fossil fuels Whilst I do love science, and how it can bring innovation, there's really a limit to how far it can go in relation to "going green" As for EV's, unless your charging of your own solar panels, it isn't helping the environment when you consider the the batteries, the mining processes required,  the manufacturing process required, and how long a batteries (read: the vehicle) lasts long term If I was supreme dictator of the world, I would ban the use of sugar for fizzy drinks and food additives and use that for ethanol manufacturing, petrol engines would be happier, and people would be alot healthier  Disclaimer: Whiskey manufacturing would still be required, so says the supreme dictator of the world Same same for all the vegetable oils that get pumped into all our food, use that for bio diesel Disclaimer: the supreme dictator would still require olive oil to dip his bread in This would take some of heat off the use of the use of fossil fuels which are required for everything we use, unless you want to go back to pre 1800 for heat and power, or the early 1900's for plastics and every thing else that has come from cracking ethylene  Would I be a fair and just dictator, nope, and I would probably be assassinated within my first few months, but would my cunning plan work, maybe, for a while, maybe not Meh, in the end in an over opinionated mildly educated arsehole typing out my vomit on my mobile phone, which wouldn't be possible without fossil fuels And if your into conspiracies, we only need the fossil fuels to last until a meteor hits, or thermonuclear annihilation, that would definitely fix our need for fossil fuels for manufacturing and power issues for quite some time  Meh, time for this boomer to cook his lunch on his electric stove and then maybe go for a drive in my petrol car, for fun    
    • It really helps that light duty vehicles have absolutely appalling average efficiency due to poor average load. Like 25% average brake thermal efficiency when peak is somewhere around 38% these days. So even a 60% BTE stationary natural gas plant + transmission and charging losses still doing much better with an EV than conventional ICE. And that's before we get into renewables or "low carbon nonrenewable" nuclear which makes it a no-brainer, basically. In commercial aircraft or heavy duty diesel pulling some ridiculous amount of weight across a continent the numbers are much more difficult to make work. I honestly think in 5-10 years we will still be seeing something like the Achates opposed piston diesels in most semi trucks running on a blend of renewable/biodiesel. Applications where the energy density of diesel is just too critical to compromise. CARB is running trials of those engines right now to evaluate in real world drayage ops, probably because they're noticing that the numbers just don't work for electrification unless our plan is to make glorified electric trains with high voltage wires running along every major highway and only a token amount of battery to make it 30 miles or something like that after detaching. Transport emissions is not insignificant especially in the US, but yes there's a lot of industrial processes that also need to be decarbonized. I agree the scale of the problem is pretty insane but EDF managed to generate ~360 TWh from their nuclear reactors last year and this is with decades of underinvestment after the initial big push in the 70s and 80s. I don't think the frame of reference should be solar-limited. France is not exactly a big country either. Maybe it doesn't work everywhere, but it doesn't have to either. We just can't live off of fracking forever and expect things to be ok.
    • Yeah, all the crude is used for fuels and petrochem feedstocks (pesticides, many other chemicals, etc etc). But increasingly over the last few decades, much of the petrochem synthessis has started with methane because NG has been cheaper than oil, cleaner and easier and more consistent to work with, etc etc etc. So it's really had to say what the fraction either way is. Suffice to say - the direct fuels fraction is not insigificant. Heavy transport uses excruciatingly large amounts. Diesel is wasted in jet heaters in North American garages and workshops, thrown down drill holes in quarries, pissed all over the wall to provide electricity to certain outback communities, etc etc. Obviously road transport, and our pet project, recreational consumption camouflaged as road transport, is a smaller fraction of the total liquid HC consumption again. If you're talking aboust Aussie cars' contribution to the absolute total CO2 production of the country, then of course our share of the cubic mile of coal that is used for power generation, metallurgy, etc adds up to a big chunk. Then there is the consumption of timber. Did you know that the production of silicon metal, for example, is done in Australia by using hardwood? And f**king lots and lots and lots of hardwood at that. Until recently, it was f**king jarrah! There are many such sneaky contributors to CO2 production in industry and farming. NG is used in massive quantities in Australia, for power gen, for running huge water pumps (like, 1-2MW sized caterpillar V16 engines running flat out pumping water) for places like mine sites and minerals/metals refineries. And there are just a huge number of those sort of things going on quietly in the background. So NG use is a big fraction of total CO2 production here. I mean, shit, I personally design burners that are used in furnaces here in Oz that use multiple MW of gas all day every day. The largest such that I've done (not here in Oz) was rated to 150MW. One. Single. Gas burner. In a cement clinker kiln. There are thousands of such things out there in the world. There are double digits of them just here in Oz. (OK< just barely double digits now that a lot of them have shut - and they are all <100MW). But it's all the same to me. People in the car world (like this forum's users) would like to think that you only have to create an industrial capability to replace the fuel that they will be using in 10 years time, and imagine that everyone else will be driving EVs. And while the latter part of that is largely true, the liquid HC fuel industry as a whole is so much more massive than the bit used for cars, that there will be no commercial pressure to produce "renewable" "synthetic" fuels just for cars, when 100x that much would still be being burnt straight from the well. You have to replace it all, or you're not doing what is required. And then you get back to my massive numbers. People don't handle massive numbers at all well. Once you get past about 7 or 8 zeros, it becomes meaningless for most people.
    • @GTSBoy out of the cubic mile of crude oil we burn each year, I wonder how much of that is actually used for providing petrol and diesel.   From memory the figure for cars in Australia, is that they only add up to about 2 to 3% of our CO2 production. Which means something else here is burning a shit tonne of stuff to make CO2, and we're not really straight up burning oil everywhere, so our CO2 production is coming from elsewhere too.   Also we should totally just run thermal energy from deep in the ground. That way we can start to cool the inside of the planet and reverse global warming (PS, this last paragraph is a total piss take)
×
×
  • Create New...