And Yet Another Problem 2 Months In....

[DC33VN]

long story short i bought my r31 and it needed a new gearbox and thrust bearing i got them changed and lately something hasnt been going right. it all started when i would shift into 2nd gear to easy without finding the gap it would just go in when i put it towards 2nd and lately when iv been holding the clutch in theres been a rattle noise as im letting it go and in gear. the worst is when im in reverse and im playing with the clutch so i dont stall it. Also the clutch feels soft so the only thing i can think of right now is that the clutch wasnt aligned correctly when they fixed my thrust bearing. also to add with the shifting of gearboxes its like impossible to get into reverse without the gears crunching a lil and the box is a recod box so it shouldn't have any problems at all. does anyone have a clue what the problem is?

Costa

[blind_elk]

If the clutch isn't aligned correctly, the gearbox won't go on.

You have oil in the gearbox? (don't flame me for that, I know it's been done before)

The clutch master has fluid? Been bled properly?

[DC33VN]

I assume thats all been done when i got the gbox replaced and the clutch fluid was changed on my service now if it was done properly i have no clue.

I was thinking that it might be my clutch master but im not 2 sure.

Someone has told me it might be my link pin thats short

[DVS JEZ]

tried adjusting the clutch? there is an adjustment on the pushrod where the pedal goes to the master cylinder, loosen the nut and wind the pushrod into the master a little then tighten the nut. dont over adjust it but. or the clutch might slip.

as long as there is a little freeplay on the pedal it will be sweet