Announcements
-
Similar Content
-
-
Latest Posts
-
By Dose Pipe Sutututu · Posted
Got bored took photos of the sub I made. Original enclosure had 2x 10" Peerless drivers in an Isobaric configuration. Although sounding nice, wasn't good for movies so I took both drivers out and sold them and replaced it with a single Dayton 10" HF series driver. The front baffled needed to be enlarged to fit the driver (something I didn't account for lol). Then of course the original 150W RMS Jaycar plate amps wasn't up to scratch and the driver would clip/bottom out, so an O-Audio 500W RMS plate amp was fitted. A year later, got bored and wanted more output, used WinISD and calculated I would get about -3dB roll of at about 21Hz with a 4" port and I think about 30cm long or so. Has been like that for over a decade, until a few months ago the amp would randomly hum as though I've taken out the RCA out and earth it against the chassis of the amp. Tested with another sub (Focal Dome, now sold) and RCA nor receiver were the issues. Concluded plate amp is fked. Took the grill off for a photo. -
As it is so original, and in mint condition, and they have ceased making 35s, I am thinking of keeping it original (not even going to do the English conversion). On the other hand, I am looking at Quadzilla mid pipes, Cobb units... -
Apparently announced on Instagram just this week; I can't access it and nothing on their website Their GTR TCM information is here: https://ecutek.zendesk.com/hc/en-gb/articles/360001830657-Tuning-Your-TCM -
By DraftySquash · Posted
HA!!! Having the same issue so dropped the car off at Chasers Performance to get the codes. I could never give it gas while turning. And it stalled at lights for the first time on my way to the mechanic today! -
By 180 wanabe · Posted
Pretty sure that the Ecutek can also tune the TCM for quicker gear changes as well
-
Recommended Posts