Jump to content
SAU Community

Vic Wasteland Thread


paulr33

Recommended Posts

just another ARM based board.

If i could load Nistune onto it and hook it up to my ecu, could do map changes on the fly. Eat your heart out powerfc hand controller :P

Link to comment
Share on other sites

If i could load Nistune onto it and hook it up to my ecu, could do map changes on the fly. Eat your heart out powerfc hand controller :P

... or you could probe the ECU's input/output signals and just make it do what the ECU does via emulation.

your car's ECU is the PC equivalent of a 386. ARM processors can do 1000 times the calculations that your ECU can do in the same time.

Link to comment
Share on other sites

... or you could probe the ECU's input/output signals and just make it do what the ECU does via emulation.

your car's ECU is the PC equivalent of a 386. ARM processors can do 1000 times the calculations that your ECU can do in the same time.

haha sounds like too much work.

Id be happy with map switching :P

Not sure nistune would run on windows CE though..

Link to comment
Share on other sites

aren't you an engineer? get on it.

haha different stream. Never dealt with computer/mechatronics/electronics engineering

you do it for me. I'll give you a six pack :P

Link to comment
Share on other sites

Removed the wing a gave my 33 a polish was quite chuffed with it really. A bit un-decided about the 'No-Wing"

SDC10518.jpg

SDC10515.jpg

SDC10514.jpg

SDC10513.jpg

gave the headlights a polish as well to get rid of the brown/orange tinge and the results were amazing

SDC10516.jpg

Link to comment
Share on other sites

boo time for work :D

water pump, Gates timing belt, idler/tensioner bearing, cam seals, crank seal, fuel filter, thermostat, bearing stud/bolt kit - Thanks Kudos Motorsport

adjustable cam gears - Access Autoworks

and possibly a 52mm allum radiator from ISC

Damn you 200,000km service :)

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.



×
×
  • Create New...