Jump to content
SAU Community

Recommended Posts

And heres another for you boys - a little old but still good.

Check out the dish on the light green S13, and how many sets of rims he has

http://vimeo.com/10050812

And just because we all wish this car was ours:

4396291051_f3ed1fb4b7_z.jpg

lol we;; he forgot to charge me for the fuel pump so im cool with that

bahaha... fail

that being said, i need to find myself another shop to take the car to. i wish trent still did mechanical stuff

:D

Contact Femno. I can SMS u his number if u want (if I still got ur number). Him or his dad do the work. Honest. Do good work and don't charge an arm and a leg.

think i might get matty to put in my oil cooler

What am I the SAU pirate? :D

Fark I should just bring my PC on next apple peel.

you're the one who admitted to having 11ty terrabytes of porn and no social skills.

I really want a 370.. such gorgeous lines. I keep seeing P platers in my area driving them. Damn rich kents..

370's aren't that exy, compared to say an M3. It's probably the only Fairlady other than a s30 fastback that I'd happily pay silly amounts for.

you only need to hard wire it running walbros that are flow rated at 15v

in the skyline it will get around 12v from the standard setup which is fine for a bosch pump or stock pump

you will gain zero by doing a hard wire. i woudlnt do it (if i was ray), just takes time which will end up costing you more for zero gain

if you put a wallbro in there and were peaking 240rwkw then yes hardwire if you insisted on wallbro, but otherwise get a real pump - ie save cost and safety

you're the one who admitted to having 11ty terrabytes of porn and no social skills.

370's aren't that exy, compared to say an M3. It's probably the only Fairlady other than a s30 fastback that I'd happily pay silly amounts for.

:D s30's....

i saw a red 370. was dumped on its arse on what looked like black BBS LMs

was in st albans if it helps lol

errr.... why?

i need to heel toe because i run a HHHDB clutch that bites like a bitch unless the revs are matched

that was a joke.

i drove a mate's (stock) 350z last night... once you go HHHDB, you never go back!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Exterior LEDs R34 2Dr R34 4Dr Position Lamp T10 T10 Winker front T20S T20S side T10 T10 rear T20S S25S150 Anti-hyfla relay TYPE3 TYPE3 tail T10 T20W Stop Lamps T20W T20W High Mount T16 T16 back T16 T20S number T10 T10 trunk T10 T10 Interior LED Item No.     Map Lamp BA9S single-sided     Room Lamps T10×31     Trunk Lamp T10     meter Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     Liquid crystal section T6.5 pedestal     Winker T6.5 pedestal     High Beam T6.5 pedestal     3 SERIES METER Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     air conditioner Early Liquid Crystal T3     Late LCD T4.2 Short     button T4.2 Middle     Hazard SW T3 Pedestal Short     Keyring T5     Cigar Socket T5
    • Howdy all,   I had my rb25det S2 rebuilt and finally started it today but have run into a few issues  Engine sounds like a a diesel easiest way to summarise like small ticking, gets louder when revs are slightly adjusted  The engine builder repainted the engine cover leaving no where for me to go off with lining up the CAS so have it as central as possible so not sure it that could be affecting it?, changed the gearbox fluid too but won’t seem to go into gear when running, and only 1 to 4 when off having a hard time finding 5th and reverse anyone got any ideas or a base for me to start off? much appreciated 
    • Well, no. It's an 023, which is pretty similar to an 040. Although it is hard to tell from the specs, as given.
    • Hmm. Maybe the (other thing I forgot about!) Haltech removes at least some, if not all, of the problem I described. I guess there is still the possibility of getting it wrong if the AC is set up/wired up for the Haltech as if it was in an R34 (simply because it's on a Neo), and that's playing foul with the R32 AC computer.
    • Glad it eventually came out Duncan!   I believe that might be 040. 044 is the inline pump, so has screw fittings in and out. 040 is more just drop it in fuel and the bottom is "open" (mesh) from my memory 
×
×
  • Create New...