Jump to content
SAU Community

Recommended Posts

Hey guys, my mate gave me a lil led display that you wire up as an air/fuel ratio display....

The wires are:

positive, negative and O2 sensor.... Ok, so the first 2 are a piece of piss....

actually, should i wire the positive throu accessories (cigi-lighter cable) or straight to battery? or other?....

now, the question i an totally stuffed on.... the O2 wire.... where and how???

all help appreciated... diagrams are excellent....

cheers.

Dave.

Link to comment
https://www.sau.com.au/forums/topic/31123-wiring-up-air-fuel-ratio-leds/
Share on other sites

From memory, you need to tap into the white wire off the O2 sensor. Check it with a multimeter - output should vary between 0 - 1V.

Hook the power off the ON posi - ie only supply power while the engine is running.

Ok, i know the sensor your talking about now.... might be fun to get to... lol....

blind_elk: when you say to hook the power off the On posi (i'm guessing the ignition switch)... how do i get in there (neva been there on this car)... just take the steering casing off? which wire? (colours etc)...

thanks again.

Just need to find something that only works while the engine is running - maybe something like the wipers (I can't remember how I did mine).

It's not so hard to splice into the wire at the sensor, but you could alternatively pick up pin 29 at the ECU.

Ok, so i'm guessing i'll be taking out the floor in the passenger foot well and looking for that wire then?...

then what would you suggest i spliced the +ve wire into? If i connect it to the ciggi lighter will it work without a switch?.... I've only ever hooked the neons up through that wire.....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah. "New pump" does not have to mean "massive pump".
    • Well, can you still get an OEM pump, and by the time you're buying a Nismo/N1 etc, just buy another aftermarket pump. It's better to have the pump able to flow more if its needed, than for your pressure to drop off. At any point in time, you're replacing the oil pump in a rebuild. Aftermarket pumps are likely going to be a better economical choice, and they don't have any negatives, even if they can flow more.   Also, when you're saying "replace the pump gears" are you meaning leave a 25+ year old housing in the engine with unknown wear, and just put new gears in? As that sounds silly to me, especially if you do have that minute amount of wear, that means your new pump gears now have a little bit more clearance beside them, which means, whelp, you may not get to build a lot of oil pressure or make a lot of flow.
    • Right, but if you replace the pump gears + put a spline or sine drive gear on the crank on a Nismo/OEM/N1/etc pump at that point do you really still want more flow/oil pressure? Let's say this is a the aforementioned "keep it simple" build, no more than ~400 kW at the crank.
    • Strength. And on the early RB26, full engagement of the pump drive.
    • I really don't understand the point of aftermarket oil pumps if your particular engine doesn't need more oil pressure. As far as I can make sense of it the problem seems to be cavitation from sucking air, maybe the pump gear design with how it interfaces with the OEM crank, and maybe the backing plate screws wanting to loosen themselves. How does flowing more oil fix these issues?
×
×
  • Create New...