Problems With Highflow Install

[3LGODZILA]

installing my highflow turbo from hypergear (just the basic highflow) and the bloody water lines are out by about 10mm, both of them. i dont really wanna bend the pipes and snap them either.

anyone else run into similar problems? i mean when i was pulling the turbo out the lines may have been bumped a bit but surely not this much.

this supposedly bolt off bolt on upgrade is turning into a pain in the ass!

[lachlanw]

they dont snap . they will bend if you are a tard . they are long enough to bolt on fine

[Duncan]

just bend slowly they will be fine. keep an eye out for kinks

[3LGODZILA]

yeh ended up getting the buggers on after i took the p clamps off n bent the pipes

[hypergear]

Garrett T3x bearing housing is slightly shorter then Hitachi bearing housings. So you need to slightly modify your water lines. I covered that in my 30 pages high flow thread, lol. I'm indexing it at moment.

Car's back on road?

[3LGODZILA]

well everythings done except for the bov. im going back to standard and im using a shitty china metal intake pipe so im waiting on a piece of silicone hose to come. she should be running 2mro

[SECURITY]

The standard oil and water lines are very flexible, I've bent mine out into a U shape to carry my compressor hose hanging in the garage

[SECURITY]

Tripple post

Edited March 22, 2010 by SECURITY

[SECURITY]

Tripple post

Edited March 22, 2010 by SECURITY