Jump to content
SAU Community

Recommended Posts

Hmm ok

Does anyone know if the diagonal there to stop the main hoop bending down onto my head in a rollover or to stop it coming in on a side impact

spose i coult make it a X and be covered for both...

Thought id post my question here before starting a new thread :D

I’ve just received a bonds six point bolt in cage for my HR31 and am worried about the position of the diagonal bar on the main hoop.

With the cage assembled, it goes from the driver’s side bottom to the passenger side top.

Is this correct? I had a look in the CAMS manual and from the diagrams it looks like it should go the other way. Will it pass log booking like that?

yeah generally the diagonal in the main hoop goes from top drivers side to bottom passenger side. like you say it stops the hoop crushing in side impact and also protects your noggin in roll over. not sure why it runs the other way but it may be ok, or like you say to be sure you can make an X and be covered no matter what. the downside is the X severely limits access to the back of the cabin.

talk to bond about why the cage is like that. I'm sure they have a good reason.

cheers baron.

on another note, im about to respray the inside of the car and have noticed that most ppl go for white.

wouldn't black or a darker colour be less glary in the sun?

The bits that are actually going to glare (cage, dash etc) are generally painted matt black or covered in floc (mmmm sexy dash).

White in the interior is easy to clean, easy to maintain, easy to find bits in when you drop them :P etc. If you don't like the stark white, then a grey is not too bad either. Mine is done in a gloss grey POR that looks pretty good and is reasonably hard wearing.

the reason many people go white is purely for aesthetics. it looks nice. when you go black you loose all the detail in the interior in a sea of black and it does get hard to find dropped nuts etc. black also gets hot. grey is a good option. always a good idea to paint the cage the same as the interior as it hides it a bit unless you don't care in which case paint any colour you want. :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depends how low and tyre size. Should fit with natural camber, skinny tyres and rolled guards.
    • Hi guys, planning to get 18x9 +25 in fronts and 18x10 +25 in rears been reading the whole thread and cant really find anything   Anyone know if these will fit a r34 gtt with no scrubbing or guard work needed?
    • They usually get made by hand as part of any such swap.
    • Was planning on getting an R35 MAF and the adapter, should this be okay? Also any idea where I could get my hands on an intake pipe?
    • I mean yes, if you're starting from scratch on an unknown engine yes you don't need to be doing all kinds of math in the background but if you're doing relatively minor changes like AFM + injectors + boost up with some aftermarket turbos it takes quite a bit of math if you want to do something like maintain OEM fuel + timing tables but compressed and then a bit more load scale up top. I think I've spent too much time working on big engineering nightmares though so I'm a big fan of trying to constrain the scope of whatever work I'm doing as much as possible and trying to get it right before moving on. For example, a local owner just did the usual E85 + single turbo conversion to his R32 GTR and nearly burned his car to the ground doing some spirited driving up the local mountains. Turbine is unshielded and too close to the hood insulation. It's tough to balance "just get the project done" and "seemingly small details can cause massive setbacks I'm not willing to deal with".
×
×
  • Create New...