Jump to content
SAU Community

Recommended Posts

Hey guys,

I'm interested to see what people consider to be a reasonable power band; IE full boost ---> Redline, for a street car.

at the moment i make fullboost at 5.2k or a touch later and pull all the way to redline (8k), this is in a built 32 GT-R with 33 N1 turbos.

Although I already knew this was rather laggy, It was driven home to me when i was given the opportunity to drive a mates 32 with GT-SS's, the response was phenomenal.

As many of you may have seen, I have been deciding which way to go with turbo's at the moment, wanting to keep the twins configuration and the standard manifold as mine has been cleaned up i have a few options available to me.

I have decided I would not want to go smaller then the output of a pair of -5's, but it seems my knowledge of what's available is lacking, as I detect a bit of a gap in the range between -5's and -10's or GT-RS's.

Sorry for the long and convoluted wind up but my main points are this:

What is an acceptable power band for a street driven track car ?

Is there a turbo that is above the -5 and below the GT-RS/-10 ?

Would -10's/GT-RS's be too laggy or surge in my application ?

I've gotten in trouble for not posting enough detail before so the car is:

2.7L or nigh on, not a stroker.

33 N1 turbos

Built engine

light headwork

portmatched inlet manifold

trust 4" intercooler

264" Inlet and 272" Exhaust camshafts both with 10mm lift (HKS)

4" Exhaust.

Cheers,

Mitch.

Edited by Nee-san
Link to comment
https://www.sau.com.au/forums/topic/317551-acceptable-powerband/
Share on other sites

GT-RS is 450rwkw+

So much more than R33 N1's will ever make. -5's will do 380-400rwkw on a good motor, GT-SS's around 330.

There are no turbos "in the middle" of any of those far as i am aware.

Yeah, i thought it a little strange that nothing sort of falls into that gap...

anyway, what do you think about useable powerband ? the power of the GT-RS's is rather appealing but if im only reving it to around 8500 RPM will i have enough room to use it ?

The -5's really do look quite good its just that in the dyno thread ive seen a fair few setups fall short of the 420+KW im looking for.

If it helps, the car will be spending probably 80% of its track life at Queensland raceway.....

Thanks for the reply mate,

Mitch.

One thing I can say.....R32 and R33 N1 turbos are about the worst thing on the market for response. Any modern, ball bearing turbo will make the same power 1500rpm sooner....or far more power at the same revs if you go larger

One thing I can say.....R32 and R33 N1 turbos are about the worst thing on the market for response. Any modern, ball bearing turbo will make the same power 1500rpm sooner....or far more power at the same revs if you go larger

Agreed, this is why im tossing up really, since as Ash has pointed out there is really no middle ground, GT-RS's or -5's for around queensland raceway it all comes down to which one....

I'm just not sure of the Pros or Cons each way as i havent personally worked with either of these turbos.

Cheers,

Mitch.

a car that makes 380 on song by say 4000 revs should be faster around a track and more fun that a car that makes 420 by 5000 revs

personally i would be looking at possibly dropping your power level a tad and shooting for some response.

you could also go a twinscroll single setup...

There are a few that go around QR on here with power between 370rwkw & 440rwkw...

Hopefully one of them can pass a bit more experienced comment :ermm:

Given you can get 400rwkw from -5's on a solid motor... it's only 20rwkw shy of what you "want" which is pretty close IMO

One thing I can say.....R32 and R33 N1 turbos are about the worst thing on the market for response. Any modern, ball bearing turbo will make the same power 1500rpm sooner....or far more power at the same revs if you go larger

Thank you for this post Duncan, i just saved myself from spending $1200 on R33 N1s

GT-SS would be the way to go if i was to upgrade when the stockers let go.

Also, how would you tell if the turbos came from a R32/R33/R34 ?

What middle ground are you looking for?

As ash said, one option is about 330kw, the next finishes around 400kw, the next goes up around 450kw.

It's not like garrett will make bolt on turbos that suit 330kw, then a new set for 350kw, then a new set for 370kw, then a new set for 390kw, then a new set for 410kw etc

it may be worth going to QR when you know skylines will be there and just asking people in the pits :ermm:

I think -5's or -9's. Its torque and response out of the corners that make for a quick track car. Its the reason why the EVO's still kick many the GTR ass at track days. Lighter weight cars, plus also more respnse out of the corners.

If your racing a fast track though and are achiving 250Km/h+ on the straights then GTRS's and more power is worth considering so you can make up some time on the straights and sacrifice some out of the corner response (and stability).

Its been my limited experience that most of the time less powerful cars are easier to drive smoother around a track, and as a result produce lower lap times.

T517z's are good for 360rwkw @ 20psi on my car... usable power from 4000 - 8500... there's your middle ground;)

dunno if you've got E85 up there but -5's with some E85 should get you over 400rwkw... heaps of power for track work IMO

Ive been in your car, before you owned it.

What a machine that thing is!

OP: As said, its up to you to find the amount of lag you're happy to put up with in the conditions you drive it in. Mine is between 3500/4000 and 8500rpm for HKS GTRS's although a 3L bottom end, that suits me, may not suit others. It would be a good idea to look through the dyno result threads in this section aswel, some decent info in there (aswel as a lot of crap results)

i wonder what would happen if given a laggy powerband you change diff gears instead

does it make the car complete ass to drive or does it reasonablly shift it lower, ie more response

the evo specs reference 4.3 and 4.5 final drive vs GTR/GTST 4.11

i wonder what would happen if given a laggy powerband you change diff gears instead

does it make the car complete ass to drive or does it reasonablly shift it lower, ie more response

the evo specs reference 4.3 and 4.5 final drive vs GTR/GTST 4.11

There's someone on this board, who i doubt will see this thread, but has recently taken out a 6 speed box and put the stock 5 speed back in.

The car was pretty responsive (given its huge single turbo) and now is just all lag.

Ive been in your car, before you owned it.

What a machine that thing is!

OP: As said, its up to you to find the amount of lag you're happy to put up with in the conditions you drive it in. Mine is between 3500/4000 and 8500rpm for HKS GTRS's although a 3L bottom end, that suits me, may not suit others. It would be a good idea to look through the dyno result threads in this section aswel, some decent info in there (aswel as a lot of crap results)

I can't imagine what another 100rwkw with the same (if not better) response would be like... but if I'm ever in NSW I'm coming round to find out! lol

I'm keen to try E85 next... figure as far as bang for buck at this point nothing can beat it

edit: yeah Paul the Mines 34GTR runs shorter diff ratios... I'm keen to try the GTS4 diffs, they are about 4.3 from memory... can't hurt the cruising speed that much, I hardly ever use 5th gear as with the big cams it runs more efficiently cruising at 3,500 - 4,000 rpm... you can hear its actually quieter at that rpm too which took some getting used to, looking down and seeing 4k on the tacho makes you want to shift up

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah kids certainly add a whole another dimension to your life.  Life ceases to be about you and more about them for a while!  And I wouldn't have it any other way.  I love watching them play sport and make new friends along the way. Wow, sounds like your mate is a good guy to know!!!  He's got some serious toys in the toy box!  Yes it would be lovely to be able to do stuff to your car without getting all tied up in boring shit like how to pay for it!!  I would describe my spending style as "aggressively spontaneous and logical but regrettable purchasing"....  That will hopefully make no sense at all which would be appropriate given that is how I buy stuff.  I'll decide at the drop of a hat that I'm buying something expensive, research the living shit out of it for 2 days straight then go out and buy it.  Then I'll have instant buyers remorse for 2 days which generally passes by the time it turns up on the front step!  If I'm feeling ballsy sometimes I'll tell my wife.  Other times it just makes its way silently passed the house and out the back to the shed, never to be spoken of again...
    • My extinguisher mounted like this unscrewed a little (Maybe from the chair sliding forward) and dumped a bit of white on my mats. I'll need to get a more narrow one for future.
    • I totally couldn't do the whole kids taking up my life thing! 😮 I find it bad enough doing 45 hours in 4 days, and then fitting normal adulting life into the other 3 with no kids! As for my mates race cars, they're AMG C63 setup for production racing. The original is what has just been stripped and a brand new shell built. The original is then going away to have some panels straightened, then it will be put back together again. Then there's a third that will shortly head off to have a roll cage put in, then build it up too. And potentially a fourth to be built too... Oh, and he has two Renault Clio D class production cars, ha ha. And when he's not racing them in the Australians and QLD production championships, he's been racing one of Chaz Mostert's Lamborghini's in GT4. They just won GT4 at the 12 hour in the Lambo. We're pushing to finish the new AMG as it has its first round (and potentially its first shakedown/outing) in under w weeks for Round one of QPC, and that round is really the shakedown to make sure it's all good for the Bathurst 6 hour, which I'll be at too. Ha ha ha Working on my project is different to his, I slowly tinker and work ways to make things happen on a shoe string budget. Hes in a good position that he has a massive workshop full of parts and tools, ha ha. He also looks after me. When his air compressor died, he just needed it working, so bought himself a new one and gave the old to me. Sand blaster unit too, and a 20t pressing. And pretty much all the shelving in my shed too as he upgraded all of his (the stuff he gave me is the expensive black Bunnings heavy duty stuff)!   I enjoy working on his stuff. No decision paralysis, and anything that's needed parts wise is just there. Plus, then I get to be hands on at the track in real racing, not just club day stuff.
    • I know which one I'd prefer to have in my garage, and which one I'd actually drive as intended
    • Yeah mate, no probs. Just swap the email addresses?
×
×
  • Create New...