Jump to content
SAU Community

Recommended Posts

1993 Skyline R32 RB25det s2

Engine:

GCG high flow BB OP6: 10000km’s old

Splitfire coilpacks: 10000km’s old

Full exhaust: HKS super dragger

HKS intercooler turn flow kit

52mm aluminium radiator (retains factory shroud)

Nismo fuel reg

K&N panel filter (factory air box)

Bosch 040

Adjustable cam gear

Power FC with hand controller

(284rwkw on 16psi)

(110,000kms on engine, 150,000 on vehicle)

Suspension:

KTS coilovers (damper, height) 10,000km’s old

Extreme Button clutch 10,000km’s old

Front adjustable camber arms

Adjustable castor arms

1.5 way diff

Rear 28mm Cusco sway bar

Hi-cas lock bar

Bendix Ultimate pads

Front/Rear strut braces

Alloy cradle bushes

RB25 Gear box

Interior:

Full GTR interior seats etc (no rips or tears)

MOMO steering wheel

Apexi boost gauge

Sony MP3 head unit

Exterior:

Full type M kit

17’ Enkei wheels (95% tread front, 40% rear)

Genuine N1 headlights

Miscellaneous:

Fresh Battery: 5 months old

All bushes have been freshen up

Redline gearbox oil

Whole hi-cas system removed

Air-con completely removed

Brake fluid/radiator recently flushed

Timing belt done

Exhaust raised (very close to the body)

Ive own the vehicle for 2 years and hasn't cause me any troubles, it is extremely reliable and I use it as my daily.

It easily gets 500kms driving around town 600kms on the freeway, I believe this is due to a great tuned which has been overlooked many times on the dyno.

The suspension has been setup extremely well, handles amazing around corners.

Under the bonnet looks stock as it retains the standard airbox and the turnflow intercooler kit. Have been pulled over a couple of times but they couldnt find anything.

The height vehicle is well above 100mm and surprisingly the exhaust isnt too loud. A lot of time has been spent trying to make the vehicle look standard and getting everything under the car freshen up.

Has been serviced every 4000-5000kms

The only bad points of the vehicle is that the paint is very rough, I was eventually going to get it resprayed but never got the chance as Im looking to get something different now. The vehicle suits someone who doesn’t mind driving around with a bad paint job.

‘note in picture stock steering wheel was put on for RWC, comes with momo steering whee, plates not included in sale ’

Any test welcome

$11000

Comes with 7 months rego and RWC already obtained

Melbourne, Eastern

0422-357-635

Cheers

Dano

post-18581-1273497961_thumb.jpg

post-18581-1273497970_thumb.jpg

post-18581-1273497978_thumb.jpg

post-18581-1273497986_thumb.jpg

post-18581-1273497993_thumb.jpg

post-18581-1273498052_thumb.jpg

Edited by DFAULT
Link to comment
https://www.sau.com.au/forums/topic/320112-1993-r32-rb25-284rwkw-11000/
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi guys, Sorry to butt in and take it slightly off course, although still on the VCAM subject.  I had VCAM put into my Tomei 2.8 bottom end and I struggle to take off because the engine has very little torque caused by VERY low dynamic compression at 60psi. But once off the mark and especially on boost, the engine rev happily all the way to 8000rpm and makes 630hp at 20psi of boost on E85 at the rear hubs. Has anyone had any similar experience or any suggestions on what might cause this low compression at low rpm? I am in the process of converting it into a 8hp transmission and with this low torque, the engine would not even stay running until the throttle is opened to more than 30% and then I loose all vacuum. 
    • Last year I got a set of MCA street coilovers for my turbo Forester after my son hitting a concrete gutter/wall on a small bridge causing the whole drivers side suspension to get bent because the rain just made the car slide out I love them, I think they were $2400. even had a hiccup of have the wrong hub configuration (my fault) so got onto MCA and they sent the correct shock ends overnight parts from QLD, for free!  I was very impressed with their customer service and quality of the product  
    • They've had some weird failures on their brake actuators. One of them was because they added some kind of lubricant to the factory fill brake fluid that aftermarket brake fluid didn't have so it would affect the seals. Another was just mysterious, probably internal corrosion or something eating away at Prius brake actuators. Parts alone for those are a few thousand USD so not a cheap fix.
    • Selling a genuine Nissan Skyline R33 Coupe 8-Pin Power Window Master Switch Part No. 25401-26U10 Price $300   IMPUL Gear Knob – Rare JDM Upgrade Upgrade your interior with this genuine IMPUL gear knob – a rare and stylish addition to any JDM build. Premium quality, perfect fit, and an authentic Japanese touch for your ride.  Price:$300 Nissan Skyline R33 (Series 2) Sedan Tail Lights Immaculate Condition OEM JDM S2 a pair of OEM Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state. Price:$900   Located in Melbourne (Western Suburbs) – Shipping available Australia wide at buyer’s expense. DM if you need anymore details.  
×
×
  • Create New...