Wiring Harness Questions, Crank Signal Wires

[ANVIL]

So my wiring harness was cut by the main ecu plug and i'm a little confused on the crank angle wiring. There is 4 wires i remember correctly pin 52, 51, 41 and 42? 2 red and 2 green. Where do these wires go to? How do I ensure I rewire it correctly? Really need this figured out...

[tuk32R]

hey mate is this any good to you? its for r33 skyline or do you need an s13 wiring diagram? Edited May 19, 2010 by tuk32R

[ANVIL]

yes that helps, but doesnt show where 52 goes?

according to this there is 4 wires, which is what i have...

[tuk32R]

heres another diagram,c how u go Edited May 19, 2010 by tuk32R

[jiffo]

Try this one.

http://s200.photobucket.com/albums/aa310/g...ent=25wires.jpg

[ANVIL]

so my situation is 41, 42, 51, and 51 are cut by my ecu plug. 41 and 42 are both the same color and 52 and 51 are the same color. i just want to re connect them the right way, if i have them switched would it matter? how can i be sure its right? looks like the just go and re connect from the diagrams?

[tuk32R]

so my situation is 41, 42, 51, and 51 are cut by my ecu plug. 41 and 42 are both the same color and 52 and 51 are the same color. i just want to re connect them the right way, if i have them switched would it matter? how can i be sure its right? looks like the just go and re connect from the diagrams?

cant say for sure but id say having them switched ,would matter..you sure there are only 2 colors of wire,do 2 of them have a color line? would you be able to tell by looking at how the wires were cut-looking for a cut pattern? ,or you didnt cut them and dont know? can you take a pic of the wires so we can see them ? what about somesort of rewire ,as you know wher they all go from the pics, is that an option at all, craig

Edited May 20, 2010 by tuk32R

[ANVIL]

I put them together as best as I can figure... They are the same colors. I just want to be sure becauseim trying to diag a no start

[tuk32R]

the only way you could tell for sure which wire is which, would be to do a multi-meter continuity test on each wire,that would tell u for certain which wire is which