Jump to content
SAU Community

Recommended Posts

Guys looking some information regarding Nistune, wanna tune My BNR with it and need some advice, how good is for under 500 hp at engine and what is the different with PFC?

i was looking for information and found nothing, only what i know at this time its cheap then pfc and also plays with ignition if there is pinging

thanks in advance

Link to comment
https://www.sau.com.au/forums/topic/323615-how-good-is-nistune/
Share on other sites

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Agreed, it is very good, I have had a Dr Drift remap & have now changed over to the Nistune. No reflection on Sam(Dr Drift's) work at all as the only reason I changed over was due to Sam being in Melbourne & I am here in Queensland so retunes have been impossible when I upgraded bits & pieces.

The Nistune has enabled me to increase my power to a little over 200rwkw in my RB20DET. I am now at the limits of the Nistune & have been advised to go for something like a wolf v4 or v500 next to achieve the 230rwkw mark as it has more scope & smaller rpm tuning increments ie 150 rpm steps.

For an everyday tuning system Nistune is great. For more advanced tuning aftermarket ECU is better.

I have more than a few mates who have PFC. They all rave about it as a great system. But correct me if I am wrong but APEXi are gone. I am not bagging out PFC at all but I believe you are better to go something more current.

Stop in at your tuners & have a chat. Take with you all the plans you have for your ride & let him/her know what your eventual goal is. That will help them help you with the correct choice for your application

The Nistune has enabled me to increase my power to a little over 200rwkw in my RB20DET. I am now at the limits of the Nistune & have been advised to go for something like a wolf v4 or v500 next to achieve the 230rwkw mark as it has more scope & smaller rpm tuning increments ie 150 rpm steps.

who told you that? the same person whos going to profit from you changing?

nistune sounds pretty good, its essentially a bridge into the stock ecu

so you can adjust everything as needed and update it as you like

apexi still exist and are still producing products, but only some in limited volumes

and youll find ECR33 PFC is discontinued as NEC have run out of processor used FP74

you can still purchase other PFC's brand new

Power is no limit for the Nistune, I have done 600+rwhp GTRs that are much more drivable than with any other ECU ive seen.

If your Tuner is selling you an ECU because the Nistune is at its limit he is is dodgy.

PFC is not anywhere near as smart as a Nistune, Nistune even use functional knock control were a PFC only warn you.

I tune for a few Shops and Nistune is the most common ECU in Nissans now and its quite often replacing other Aftermarket ECUs inc PFC.

Perth car scene is now targeted by the cops and Emission tests are the norm with the Nistune making this test very simple even in some hardcore cars.

Edited by N I B

the pfc has a slightly better mapping system than the nistune (more cells) but the nistune is a better overall system in my opinion. sure it doesn't have a hand controller, but the cost of the unit plus tuning is generally less than the cost of just a pfc itself without tuning.

power wise it should produce the same power as any other unit as the power you make is purely based off the skill of the tuner rather than the ecu.

it should also handle a hell of a lot more power than 200kw on a r32. according to the nistune site the speedlab got 373kw out of a rb20 running a nistune.

The Nistune has enabled me to increase my power to a little over 200rwkw in my RB20DET. I am now at the limits of the Nistune & have been advised to go for something like a wolf v4 or v500 next to achieve the 230rwkw mark as it has more scope & smaller rpm tuning increments ie 150 rpm steps.

For an everyday tuning system Nistune is great. For more advanced tuning aftermarket ECU is better.

Have a read of the Nistune thread http://www.skylinesaustralia.com/forums/Nistune-t181930.html or some of the dyno result threads, there are plenty of cars making over 500rwhp and still not hitting the limits of the Nistune.

Coming to think of it, i had also heard they had gone out of business. All lies lol, i never really paid much attention to it

Edited by Hanaldo
Power is no limit for the Nistune, I have done 600+rwhp GTRs that are much more drivable than with any other ECU ive seen.

If your Tuner is selling you an ECU because the Nistune is at its limit he is is dodgy.

PFC is not anywhere near as smart as a Nistune, Nistune even use functional knock control were a PFC only warn you.

I tune for a few Shops and Nistune is the most common ECU in Nissans now and its quite often replacing other Aftermarket ECUs inc PFC.

Perth car scene is now targeted by the cops and Emission tests are the norm with the Nistune making this test very simple even in some hardcore cars.

Just wanted t double check and sau is the best place of that ;) bought the licensy cable and almost pay amount same as used pfc cost and doesnot wanted to make mistake

The Nistune has enabled me to increase my power to a little over 200rwkw in my RB20DET. I am now at the limits of the Nistune & have been advised to go for something like a wolf v4 or v500 next to achieve the 230rwkw mark as it has more scope & smaller rpm tuning increments ie 150 rpm steps.

did something happen between Nistune and Wolf? heard similar stories before as well

anyways, 290rwkw, Nistune - maps for both BP98 and E85 - nice piece of kit ;)

i cant see how nistune would be at its power limits

its just maps and numbers

the only time it would be phyiscal possible to be at a power limit, is when you max injectors

air

fuel

spark

make power, not mapping, so it doesnt sound right to me

i would not expect power gains changing ECUs

you would only see a power gain if its not tuned correctly

Agreed, it is very good, I have had a Dr Drift remap & have now changed over to the Nistune. No reflection on Sam(Dr Drift's) work at all as the only reason I changed over was due to Sam being in Melbourne & I am here in Queensland so retunes have been impossible when I upgraded bits & pieces.

The Nistune has enabled me to increase my power to a little over 200rwkw in my RB20DET. I am now at the limits of the Nistune & have been advised to go for something like a wolf v4 or v500 next to achieve the 230rwkw mark as it has more scope & smaller rpm tuning increments ie 150 rpm steps.

For an everyday tuning system Nistune is great. For more advanced tuning aftermarket ECU is better.

I have more than a few mates who have PFC. They all rave about it as a great system. But correct me if I am wrong but APEXi are gone. I am not bagging out PFC at all but I believe you are better to go something more current.

Stop in at your tuners & have a chat. Take with you all the plans you have for your ride & let him/her know what your eventual goal is. That will help them help you with the correct choice for your application

who tuned your nistune? many workshops i've spoken to all say PFC is good. only one workshop said PFC are good but they steer customers away from it and recommend nistune due to the fact they are cheaper, also does everything the PFC does

anyways, 290rwkw, Nistune - maps for both BP98 and E85 - nice piece of kit ;)

by 'maps for both BP98 and E85'; do you mean you can switch between them on the ECU from one day to the next, or the different tunes are on file at your tuner's shop?

really happy to hear good for it, anyway why it shouldnot work properly if standart ecu is remapable? Guiltoy will tune it and i will post up results, car will be boosted with GT35R

more a point to say it's versatile enough to handle to the two fuels, etc...

i've got the USB consult cable, but don't have a laptop. If i did, i'd put NIstune on it and load the two maps. But there is an E85 outlet 5mins from my place, and for a car that's barely driven, i don't have the to switch constantly.

i guess to answer your question, yes you could easily switch between the two with a laptop and Nistune (still have to drain the tank first though).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • All I can say Duncan is good luck and I hope that Neil did not run any E85 in Cheryl. I have recently experienced the full spectrum of fuel tank issues in my R33's that had been caused by E85 and contaminated fuel. When you take the cover off the top of the tank and have a look inside you will get an understanding of how easy it will be. Best case situation is clean fuel with minimal contamination. My GTR was like this and it was a very simple operation to just grab the fuel pump carrier bracket and slide it up and out of the tank. My three GTS_T's had different levels of fuel contamination that was probably caused by E85 in the fuel.  In the worst case all of the metal components in the tank had rusted to the point where there were pieces of rusted metal swirling around in the tank. This required the removal of the exhaust, the tailshaft, the complete rear cradle and the fuel tank. The components in the tank were that rusted that it took days to get the fuel pump carrier and the mounting brackets out of the tank. When the tank was finally cleaned, everything inside the tank had to be replaced. With the tank all back together I could then reinstall it in the car along with everything else that had to come out. Good luck and I hope that you find a clean tank.    
    • It is a two door. It is black and also still has the OEM wheels and stereo. Exact model would be KR_R32RGFEL_SS According to GTR-Registry.com is a 2 Door Coupe; RB20DE; 2WD no HICAS; MT.F5; (11L) Projector Headlamps and Fog Lights; (12_) Electronic Active Full Auto Air Con (Climate Control); (13-14SS) V Selection -- Which seems to be accurate description of my variant. Will try to upload a few pictures soon. The OEM wheels look like the below image. Image is taken from the goo-net-exchange website.  
    • Time: Saturday 18th January - 9am -10:30am Where:  Cafe By Lamanna 10 English St, Essendon Fields VIC 3041  - https://g.co/kgs/mhVKvAB Registration: So we can give the cafe a heads up on rough booking numbers please rsvp below Registration Link: https://forms.gle/wPtfj9Gp8bvCiouo8
    • Welcome Gabriel. At least your car has a glorious RB and not the shitty CA18. As MBS206 mentioned all the good bits can be added later. Two doors or four?
    • And half of them have been converted to turbos.
×
×
  • Create New...