Jump to content
SAU Community

Recommended Posts

Hi guys,

I am looking for a ECU to engine bay loom for a R33 S1 because the previous owner has cut out the ECU and plug. So now I am left with a bundle of wire where the ECU mounts.

If I cant find a loom can I use any other models plug? ie R32 or anything else if I rejoin the wires down near the kick panel?

Also looking at the wiring diagrams it looks like there is double ups in colours etc, red,green, white/black, black, black/red for example that go to different pins on the ECU. Hope that makes sense. Bit confusing but it shouldn't matter which pin they go to as I assume that they are going to the same parts?

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/327762-r33-ecu-plug-and-loom/
Share on other sites

there are a few different plugs i think. AFM and TPS are different (not sure if they are on the loom you are talking about). also not sure if where it plugs into the coil loom is different as s1 has the ignitor unit there and the s2 doesn't.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've uploaded logs / the current map to Gdrive if anyone has any ideas. https://drive.google.com/drive/folders/1FPnr22Z-EilG7tYdHSi0Qb07P2jfFLKV?usp=sharing
    • I'm running a Haltech Platinum Pro with the stock map for the RB20DET + tweaks for my build. When I started it this morning, the IAT was at 32F/0C (Outside temp was ~42F) and the AFRs went off the scale for my AEM gauge. I let it run for ~30 seconds then turned it off. I then did a smoke test, by hooking into a vacuum line directly behind the throttle body, and confirmed there was no leaks ( i let the smoke tester run for ~5 minutes / confirmed it was generating smoke before hand ). I then started the car again, after fixing a power steering leak.... and it seemed to be happy for ~30 seconds (was at ~11/12), but then seemingly shot back up to ~18 again. I then let the car run for a few minutes, thinking this was just cold start related, but the AFRs never came back down. I didn't let the car fully warm up, so maybe this makes sense, but I'm not sure what to do? The AFRs, when I last ran it, were normal, but because of personal reasons I haven't been able to break in the car. It was rebuilt last year. Engine / Mod list: Supertec pistons Spool rods Kelford 270 cams and Springs Stock crank Deatschwerks 900cc injectors Walbro 255 (Wired directly to the battery relocated in the trunk) NKG Audi R8 Coil packs + Conversion Harnesses from Wiring Specialties Holset HY35 turbo Haltech Platinum Pro ECU Haltech boost controller (wired in for high boost RB25 Neo transmission + needed bits for the speedo to work  
    • Not great at getting the camera out fast enough for cars driving. Even in traffic. S15 is in front of the kei truck.
×
×
  • Create New...