Jump to content
SAU Community

Recommended Posts

Howdy!

So, I have been getting around in grandpa's old stock as a rock r31. Things were going well, but I ran it low on fuel and it ran poorly for 30 seconds and died. I actually thought I had run out of fuel, so I topped the sucker up and it ran again.

Then it stopped running again the next day.

I drained the fuel tank, added injector cleaner and changed the fuel filter, and the car ran like a champ. Then it stopped again after 20 mins.

I decided I must have fouled the fuel pump and (being the weekend) I organised a couple of crappy 2nd hand fuel pumps, and the car ran again. Then it stopped again.

So I tried the other spare fuel pump and that went well for another 20 odd kms then it stopped. Again.

If I disconnect the fuel line at the filter when I start the car fuel sprays out everywhere. After a short drive the car dies, and when I disconnect the fuel line I get no fuel spraying anywhere. However, if I wash the car, or go for a couple of beers, or sit around for a couple of hours the fuel starts pumping again, and I can drive another few kms before breaking down again.

Do I have (now 4) dodgey used fuel pumps, that only work sometimes, or is there another problem - maybe like a bad earth, that causes the pumps to cut out sometimes then come back to life after a bit of a break.

Thanks.

Link to comment
https://www.sau.com.au/forums/topic/329695-r31-intermittent-fuel-problems/
Share on other sites

Drew,

I would be looking at the Fuel Pressure Reg & if that's not the issue try the injectors, but both of these don't explain the lack of fuel at the filter.

I had a similar problem with the KHR30 and I fixed it by chucking out both the old fuel pump and pressure regulator. Now it goes like a dream with a 910 copy fuel pump & right angle banjo fittings.

The R31 has an in tank pump set up, correct? If this is the go, look at the filter sock on the end of the pump, as todays unleaded fuel turns to nearly acid when it sits for a while and starts eating the fuel tank. The sock might have some rust & shit in it that blocks it up occassionally.

Cheers, D

Not even sure what a fuel pressure regulator is, but I'll look it up and try swapping it. The sock on the end of the in-tank filter looks ok. Besides, the problem is affecting multiple fuel pumps/filter socks, and at a glance they all look right.

When you drained the tank, did you get much crap out of it and did you stick a hose in it and wash it out? When I first brought the purple DR to Sydney, what we got out of the tank was brown and we washed it out with a hose and let it dry out and then fitted a pre filter to be sure what was going into the pump was clean fuel. Works sorta like an intank filter sock.

Cheers, D

Actually the fuel looked pretty good, so I only drained, and didn't flush. Flushing and prefilter sound like saavy ideas. The r31 guys are suggesting that my crank angle sensor may be sending bad info to the ECU about when to send fuel. I'm going to try that, too. Apparently they are vunerable to malfunction when hot.

I heard of a similar story years ago with a Patrol. Long story short, there was a piece of plastic floating around in the fuel tank. Every now and then it would block the fuel pickup. After stopping the engine, the plastic would float away and everything would be OK until the next time.

As Dennis suggested, you might need to give the tank a really good flush.

Can't see the CAS stopping the pump, though.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Read the ECU for fault codes or have someone else do it. A faulty coolant temperature sender is usually listed in ECUs. If the sensor itself is not busted it can also be a bad ground connection. Or in a really unlucky case, damaged wiring.
    • Can't be a Futjitsubo as those are made with a flex piece and Reimax is smaller in pipe diameter. If anything it is closest to a Mines pipe, but evidently it is not an actual Mines pipe.   Classic word humor
    • Alright I will try to not forget.   As GTSboy replied to you already, problem is mainly the mismatch between the actual exhaust part and the denomination in the papers. That basically just looks like tampering to a cop, if they were to check your car and notice. If it had been done right they would have clarified it to be a custom pipe and just given it a certain part number that you have to engrave or weld onto the pipe. I will definitely inquire on what to do. Changing the pipe wouldn't be my favorite solution as it costs a bunch of money and the cat was fitted with the front pipe and exhaust under the car, and if the front pipe flange does not sit in the OEM location the cat will need to be refit for any other pipe to work. It also usually doesn't need a brand name or something like that, but more something like a part number. Usually for exhaust parts, on silencers and cat units specifically, there is a badge that reads the certificate number that belongs to these exhaust parts under EU regulation. You get these numbers after you put a part or group of parts through the tedious testing according to EU vehicle legislation and they pass. You can find these "part numbers" on various parts throughout a EU vehicle. On windows, headlights, engine parts, seat belts and so on. All these parts have gone through standardized testing and acquired a so called ECE or EG Certificate that makes them legal to use by themselves in all countries that adhere to these standards. You can also not alter these parts in any way, if you do they become illegal. An example for stampings on an exterior lighting part, the people who need to know can find the documentation for this unit in a database. I do not know what all the standards and so on mean.
    • If that was the case I suppose you could call it "Mein's" brand....  ... I'll see myself out... 😅
×
×
  • Create New...