Jump to content
SAU Community

Recommended Posts

Any pointers?

I've jump started it from all sorts of things from GTi-R to a tow truck with twin batteries it still wouldn't start. In fact I've melted 2 jump start cable..

It just crank slowly, crank again then crank again till the cable melts...but funny enough it did start last weekend. Any ideas? It seems like there's not enough power to the starter to crank it into life. Funny enough the power windows refused to work as well.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/
Share on other sites

it might help if u have fuel in the car:D possibilities are starter motor?? did u play with the fuses?? i played with the fuses last time in my car and put one in the wrong place and it wouldnt jump start at all...it would crank over and then die. have u tried putting another battery in your car to see if its the battery at fault?

i dunno....good lucks with it

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-662476
Share on other sites

There's fuel but doesn't seem like a whole lot in there. Possibly drop another 5L in there and see how it goes...

Which fuse(s) should I check?

With batteries..haven't tried that but the battery shouldn't matter - at least with my other cars even if the battery's screwed, I can still jump start it just that it can't be charged.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-662538
Share on other sites

coils not producing spark? spark plugs stuffed? I would say if you have cranked this car till the jumper cables have melted you would have done some serious damage to the starter, as it is only ment to run for 5 secs or so. Also, Im with Chucky, make sure your engine is properly earthed to the chassis, because a bad earth connection can make wires heat up and melt, especially when your using lots of amps when cranking.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-664129
Share on other sites

And if your +ve wire or -ve has melted that would explain the slow cranking short of a stuffed starter...

Sumo

P.S. Sometimes its easier to just take it to a autoelec and they should if they are decent give you a heads up on what is going on, free of charge. I know at my work we do.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-664166
Share on other sites

My experience has been that when the battery has totally died, and you need to jump start it, you need to have the 'jumper' connected to the 'jumpee' and engine idling for several minutes. The 'jumpee' battery needs at least some charge in it.

Also, the ECU needs something like 7V to activate itself. Cranking on a low battery will reduce the voltage available to the ECU to below the threshhold, and so the ECU will not activate, and if it isn't activated, it can't tell the coils to fire.

And don't forget, most cars have the battery up front, so there's not that much cable between the battery and the starter. The 33 has to get volts all the way up to the front from the boot.

If you can, connect the+ve jumper cable directly to the +ve of the starter motor, and the -ve directly to the engine block.

Alternatively, go and buy a new battery, and you'll avoid the "melted starter cables" syndrome.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-665084
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...