Jump to content
SAU Community

Recommended Posts

Any pointers?

I've jump started it from all sorts of things from GTi-R to a tow truck with twin batteries it still wouldn't start. In fact I've melted 2 jump start cable..

It just crank slowly, crank again then crank again till the cable melts...but funny enough it did start last weekend. Any ideas? It seems like there's not enough power to the starter to crank it into life. Funny enough the power windows refused to work as well.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/
Share on other sites

it might help if u have fuel in the car:D possibilities are starter motor?? did u play with the fuses?? i played with the fuses last time in my car and put one in the wrong place and it wouldnt jump start at all...it would crank over and then die. have u tried putting another battery in your car to see if its the battery at fault?

i dunno....good lucks with it

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-662476
Share on other sites

There's fuel but doesn't seem like a whole lot in there. Possibly drop another 5L in there and see how it goes...

Which fuse(s) should I check?

With batteries..haven't tried that but the battery shouldn't matter - at least with my other cars even if the battery's screwed, I can still jump start it just that it can't be charged.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-662538
Share on other sites

coils not producing spark? spark plugs stuffed? I would say if you have cranked this car till the jumper cables have melted you would have done some serious damage to the starter, as it is only ment to run for 5 secs or so. Also, Im with Chucky, make sure your engine is properly earthed to the chassis, because a bad earth connection can make wires heat up and melt, especially when your using lots of amps when cranking.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-664129
Share on other sites

And if your +ve wire or -ve has melted that would explain the slow cranking short of a stuffed starter...

Sumo

P.S. Sometimes its easier to just take it to a autoelec and they should if they are decent give you a heads up on what is going on, free of charge. I know at my work we do.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-664166
Share on other sites

My experience has been that when the battery has totally died, and you need to jump start it, you need to have the 'jumper' connected to the 'jumpee' and engine idling for several minutes. The 'jumpee' battery needs at least some charge in it.

Also, the ECU needs something like 7V to activate itself. Cranking on a low battery will reduce the voltage available to the ECU to below the threshhold, and so the ECU will not activate, and if it isn't activated, it can't tell the coils to fire.

And don't forget, most cars have the battery up front, so there's not that much cable between the battery and the starter. The 33 has to get volts all the way up to the front from the boot.

If you can, connect the+ve jumper cable directly to the +ve of the starter motor, and the -ve directly to the engine block.

Alternatively, go and buy a new battery, and you'll avoid the "melted starter cables" syndrome.

Link to comment
https://www.sau.com.au/forums/topic/33004-r33-wouldnt-start/#findComment-665084
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
    • To re-cap, I bought: https://www.alibaba.com/product-detail/Lsailt-8G-Infiniti-Q50-Q60-2014_1601171829627.html?spm=a2756.trade-list-buyer.0.0.2cd476e9FTIlKE As you can see, if I bought 20 it was $653, but I bought 1 so it was $1,170. I was very tempted to buy 2 and resell 1 at 25% cheaper. @MBS206, I am not sure if they do a Kluger one, here is their list but it might be there under a global model name: http://www.lsailt.com/product/android-interface?page=1 Keep in mind these full android replacements have basically all the bits a phone does (cpu, ram, storage, wifi, bluetooth, usb interfaces) other than a screen (it uses a host), thus the $800+ cost. Android Auto screen mirroring is MUCH cheaper as it's just a cut down shell, input mirroring and output mirroring BTW I also need that "screen off" feature, it is much harder to see wildlife even if a dash is reasonably dark. Both the Fuga and V37 have display off buttons for night use, they just come back on for a second or 3 if you interact with it, eg skip a song.
    • I use FCC car launcher. It has an option for different backgrounds, so instead of turning the screen off you can swipe 'up' to a black screen with no background/icons. (mine has the time on it only). It's kinda nice. Also lets you use gestures to say swipe to go to next song, etc.  
×
×
  • Create New...