Jump to content
SAU Community

Recommended Posts

When i bought the car , the bloke said that he had the car on a dyno for 4 hours.

I was wondering how often a car should be dynoed, it was last on a dyno on 24/10 2001. My car is running great but VERY VERY RICH, which is supposed to be a safety thing.

Should i get the car on a dyno to see how things are or is it a waste of money & time.

Link to comment
https://www.sau.com.au/forums/topic/33131-how-often-to-dyno-tune/
Share on other sites

if it is running VERY VERY RICH, then that is sort of an over kill.

I think that a safe air:fuel setting is 11:1 or even 11.5:1

above that would be too lean for constant on boost type driving.

My R32 GTST was at about 12.3:1 on MAX load when on the dyno but it never had a problem cause it would only be on that for a few seconds at a time.

If your car is as rich as you make it out to be, it would be effecting performance, it would be fouling up your plugs and oxygen sensor and you would be getting SHIT fuel economy..

The way I see it, you have an R33 GTR.

It is worth what... over $40K??

spending $70 for a single power run on a dyno would show you HOW rich/lean your car is...

then I believe the most expensive I have seen is about $110 per hour for dyno tuning at like Croydon Racing Development (CRD) at Silverwater.

If you have a POWER FC or some sort of aftermarket programable ecu, then it wouldn't even be more than an hours worth of tuning..

I think for under $200 you could get your car tuned to perfection and still be safe.

As for how often you need to get your car dyno tuned, once it's set, you shouldn't have to retune unless you do another power mod.

say you went and got it tuned and then later found that you only had a cat back and got some dump/front pipes which resulted in some more boost and power, you would be wise to make sure that this hasn't put your A:F ratio out of whack...

NOTE: the above is my opinion.

Some people say that the optimal air:fuel ratio for a turbo car is 12:1....

But I personally would prefer to be a little on the saefr side of Optimal...

Hope that helps..

Pretty much spot on there GTST...

Don't expect to get your car tuned at CRD for any less than $800 though... That's their minimum cost... Jim is an excellent tuner, but quite expensive...

The optimum ratio for air:fuel on any combustion engine is about 12:1 - if you are looking for power.

However, if you run an engine at 12:1 you are looking at over-heating problems, which is why most engines run slightly rich, because with less air in the mixture the engine will run cooler.

You probably already know this!

Thanks for the info GTST, its running too rich , i've alreadly replaced the 02 sensors 2 months ago & i'm not getting too much above 200km city driving. When i give it in 1st gear, off the mark a big black cloud of smoke comes out about 2-3 metres high (like a diesel truck)lol.

The car has a lot of mods ( standard internals i think), it was taken to the HKS workshop in Japan before it got imported to aust & it only produces 245awkw, but it does feel quick, people on this forum seem to be getting that on stock turbos & with less mods?

I've got to take it to eastern creek for some times in the near future.

200km to a tank??

Jebus man...

you weren't kidding about it being rich..

I would definitely spend a few hundred tuning it..

that's not right..

I'd also recommend a spark plug change after the mixtures are corrected..

I think that on your baseline run, the A:F ratio's will be off the chart.. as in below the 10:1 reading that most dyno's are calibrated to.. (I think)

245kw at the wheels! I love rb26s.

If you're blowing that much smoke and getting such bad milage i reckon you need to have it looked at. Theres probably another 20kw hiding in there easy :)

If it is only blowing smoke when you put your foot down then it may just be the pump settings are out of whack and it needs a bit of road tuning to iron out drivability issues.

Still talk to a tuner, dyno time is a great way of seeing what your car is doing anyway so give it a go

"Don't expect to get your car tuned at CRD for any less than $800 though..."

My car (the magna, not the FD, obviously) was on the dyno for several hours (quite a few actually) and he charged me about $200... (actually, that covered install too...)

It was a sponsored car (unichip sponsored, among others) and I was giving him a good plug on my website though!

Nice guy - and a great tuner!

Definitely expensive - but you get what you pay for

It only blows smoke when i'm taking off & a few seconds after reving the engine (stationary). The dyno tuner said that he had noted it down when the car was last there.

He said that there was a air flow metre problem caused by a bad compressor surge. He said that some one had modified the turbo housing or the turbo wheel.

Where do i start to correct this problem. He said that he doesn't deal with those type of problems.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oh yeah forgot to also mention need to also unplug the IACV as well. Thanks for the reminder @MBS206 Unplugging the TPS takes it out of closed loop so you're able to screw down the IACV without the ECU trying to add/subtract timing to maintain the idle (not sure PowerFC can even do this, but Nistune and the OEM definitely does)
    • For sale is my 1999 Nissan Skyline R34 GT-T, tuned to 234 kW / 313 hp. I've had the car for a few years as my daily driver. The car is original (as far as Skylines go), with only a few minor upgrades to enhance performance and driving experience, as typical for such a car of its age. Overall, it is in great condition with no body rust, thanks to its earlier import date. It features a top-notch security system (not literally, but it's great!) with remote start and still functional 4-wheel steering via HICAS. It comes with several performance and handling upgrades, including:     Hypergear 450HP Turbocharger running 17 PSI boost, installed mid-2021 by Jaustech     550cc injectors     Nistune ECU     Front-Mount Return-Flow Intercooler     X-Force Stainless Steel Exhaust     Upgraded engine mounts     Bottom end bearings replaced     BC Coilovers     Lenso DR1 rims     Bridgestone Potenza Adrenalin RE003 TL 245/40R18 97W tires, fitted early 2023 The interior is mostly stock, with a few additions:     Viper Satellite Tracking System with remote start     Bluetooth Double-Din Touchscreen Head Unit     Steering wheel cover Cons:     A few paint imperfections here and there     Driver’s seat shows more wear than the others. It's not torn at all, but I've added a seat cover to protect its condition. I also have a CarVX Vehicle History report available for serious buyers, so you don’t need to purchase it yourself. Price: $26,000 ONO.
    • I've had two suzukis in the past have an extremely hard time turning over and not starting after sitting for a few weeks. Ended up the alternator would seize up causing the starter to force. Same issue both times.  Maybe they're sourcing their alternators from the same place...
    • Ah right. Maybe my rb just loves chewing through batteries lol.
    • On the R34 can't you just unplug the IACV? This is the way I've always done it on the R33. Disconnect IACV, get it idling around 650rpm, and then do a power reset on the ECU to get it to relearn idle (factory ECU).   The big reason no one has touched on as to why you'd want to get the base idle right, is that it means the computer needs to make smaller adjustments to get a good idle at 700-750rpm.   Also, cleaning the IACV won't normally make the car suddenly idle lower or higher. The main issue with the IACV gumming up is that the valve sticks. This means the inputs the ECU gives, aren't translating to changes in air flow. This can cause idle choppy ness as the ECU is now needing to give a lot of input to get movement, but then it moves too far, and then has to do the same in reverse, and it can mean the ECU can't catch stalls quickly either.
×
×
  • Create New...