Jump to content
SAU Community

Recommended Posts

Dont think there is a bearing in it either. I've had mine off using the SK DIY timing belt replacement. AFAIK it is two parts bonded together by rubber.????

Ther is a place at 17 Mile Rocks that has Stagea bits. They are in the Yellow Pages. A bit EXXY though, but close.

the only thing i have ever see go wrong with a harmonic balancer is the rubber bonding seperating or the key way flogging out

sounds a bit suss if you ask me

and there is no bearing on a balancer they must be talking about the idler for the timing belt which should always be replaced with the belt

Further to my last i dropped in and inspected myself.

Timing belt had dropped a tooth, timing bearings made the sound of sand when turned, harmonic balancer interior rubber was perishing.

So i went to just jap, and ordered the following

- Gates Racing timing belt kit

- HPI clear timing belt cover (bling bling)

- Ross Tuffbond harmonic balancer

Total cost $1028.70 with a 10% trade discount!

Kinda lucky in a way i caught it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hello everyone, I am from Malta and have recently bought myself a fully stock 1992 Nissan Skyline GTS. It has the RB20DE engine and thus is NA. Unfortunately, not a lot of information can be found online related to the GTS, unlike the information for GTS-T and GTR variants. Apart of the Skyline, I also got a 1984 Porsche 924 2.0l NA and a 2002 Renault Clio 1.5DCi for everyday use. Excited to be apart of the community and perhaps get better information on cars such as the GTS.
    • The fuel pump bracket just slides straight up.  Below is a pic I stole off a site. But basically put hand in for fuel pump, wiggle it all about a bit while pulling up. 
    • Went digging Duncan, there's another "item" that sits down under the plenum that the second pipe from the IACV goes down to. I believe that's the one that is apart of the cold start portion, and it then comes back up under the middle of the factory top plenum. I believe you will find it is unneeded on the forward facing plenum on Cheryl.   I just went digging further for some pics on the location of the one way check valve, and found something that confirms my thoughts from the first half of this point. I feel you can just block off that port that is coming down.     I can also confirm, the other line that you were thinking for vacuum that will just need a one way valve put into Cheryl is 100% correct too. The one way valve is normally screwed into the back of the factory inlet plenum.
    • You’re an absolute legend man. Cheers.  
    • The rule of thumb for any GTR thats doing a single turbo conversion is..... seqy... and when i say seqy, i dont mean the pos PPG either. *flamesuit on*
×
×
  • Create New...