Jump to content
SAU Community

Recommended Posts

hey guys, getting some coilovers on the 33 tomorrow and this is the only chance ill have for awhile to adjust the hight, right now im roughly running 200mm but i was just wondering whats the lowest comfortable hight you've found for city driving (where you don't scrape ever 10 seconds) cheers guys :D

Link to comment
https://www.sau.com.au/forums/topic/333708-lowest-comfortable-hight/
Share on other sites

I am currently at 101mm (just passed legal) = crap

Ill be honest its pathetic.

You look like a clown trying to get up any drive way.

And the massivest angle over speed humps wont make you look any less gay.

There is a thred somewhere about the idea height for skylines. 150 somthing??by memory.

Maybe do a quick search.

=)

Mine sits 120mm at the lowest point (cat converter) and 130mm is the next at the front bar. I only have trouble getting into really sharp sorts of driveways where the bar scrapes, but even then taking them at an angle generally goes OK. So 90% of my driving is hassle free if that's any help?

my front bar sits at about 98mm off the deck.. it's a bit of a drama with driveways and speed bumps but it only gets driven on weekends and i choose carefully where it goes.. As a daily this would be too low for me especially in mackay lol..

Cheers Matt

bumpsteer ... pfft its not good but as hamish said coiloverds dont have much travel and the low ass height they dont move at all, + having a roll cage makes it way harder again so u definately feel it haha.

but thats what sports cars are about

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • On R32s etc the variable resistor of the TPS is pretty much only for the auto trans CU. The switch is the idle position. Yes, later ones want to see pretty close to 0.45V to declare idle position.
    • TPS sensor needs to be adjusted such that idle voltage is 0.45V, then relearn the TPS if applicable. From what I recall in the R32 GTST and similar ECUs they care far, far more about the actual TPS closed switch but later models seem to only keep track of voltage.
    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
×
×
  • Create New...