Jump to content
SAU Community

Recommended Posts

Hi Guys,

I'm after some recommendations on a cheap Amp & Sub, audio is not my number one priority in the car, so it ceratinly doesn't have to be an award winning setup.

How are these for example, really bad?...

http://www.strathfield.com.au/product.asp?ProdID=76

http://www.strathfield.com.au/product.asp?ProdID=537

At the moment it still has the 4 speaker setup, with a semi decent Pioneer head unit that does the job. Front speakers are shite, rears seem OK, sorry for the lack of detail.

Do you run the sub and rears off the amp, and run the fronts off the head unit?

Where is the best place to install the amp & sub, I value my boot space, next to the battery?

Thanks for any help.

Are there any threads for newbies to read on audio?

Link to comment
https://www.sau.com.au/forums/topic/33728-audio-dummy-here/
Share on other sites

by the looks of it, it seems u have around less than $400 to spend on a sub and amp.

If u front speakers are good, yes, amp them with a 4 channel amp with 2 channels to the front, and the rear channels bridged to the sub.

leave the rear speakers running off the headunit.

Good subs for $200 might be the Alpine type s or the Fusion few-12 or JL-audio w0's . For $200 for the amp, look at something like a jaycar 4x50rms. This will bridge to 150rms at 4ohms for ur sub and 2x50rms for the front speakers. IMO those 3 subs above r better than that mtx. U'll need some money for cabling aswell, if ur gonna leave ur setup like that, 8Gauge cabling should be enough. 4G would be better, but i dont think u'll need it. Leave about $40 for that + all other wires rca's etc. $20 for wood for a box if u can build it urself. (sorry i went over the budget..but with the amp and subs u should look for 2nd hand or something and get the best possible thing u can when ur on a tight budget..maximise what ur getting).

good luck.

Link to comment
https://www.sau.com.au/forums/topic/33728-audio-dummy-here/#findComment-676748
Share on other sites

Pretty much same advice as nav2k.. just get some good fronts .. you can do without the sub for a while until you really want good big bass (or maybe you don't care about bass, depends what you listen to).

Best to stay clear of some of the "no-name" brands as while they might often say "800watt" 800watt can mean anything, and they could sound shithouse even at mild volume, and can have bad background hiss, etc which can really shit you when listening to quiet bits of music. Soon as you put it in you'll regret it. For under $200 for a "200watt max peak per channel" (equates to around 50wRMS.. not much more than your face unit), i'd definitely stay clear!!

For a reasonable 4x channel you're probably looking closer to $400 min. Like Nav2k says also, jaycar has some reasonably priced amps in the budget end. Just looking at their latest sale catalogue I have in front of me.. they have a 4x100w RMS (@4ohm) for $379.

I've got a mono amp of theirs powering my 12" sub, and pretty good... I only paid $130 for mine too! (a SAU group buy i organised).. RRP is about $200 - so you could look at that if all you want is an amp to power a sub.

Best just to get 2x best you can afford for front, 2x reasonable for rears.. and wait until you can afford the amps, etc. For many sometimes just 4x speakers powered off the face unit are fine.

Link to comment
https://www.sau.com.au/forums/topic/33728-audio-dummy-here/#findComment-677765
Share on other sites

yeah, I agree with the predator. Its no good getting a lot of bits n pieces if your not gonna get quality components cos all you'll end up doing is complicating the signal path which increases distortion. If you look at it another way: say if you had an awesome sub but a crappy amp, all the sub will do is let you hear the crappy signal from the amp clearly. Stay simple and get good bits, that way you can always add to what you've got, and not suddenly decide that what you have is crap once you get something better. A really good 4 speaker or even 2 speaker config if its set up right will destroy some of the no name budget sub n amp packages.

Actually, if audio is not ur priority you might want to consider some 6x9s and ditch the sub idea. True 6x9s aren't good for clarity, and most audiophiles would stay completely clear of those, but they are a good compromise for base. Think of it this way: the oblong shape stuffs up the clarity, but each one has approx surface area of an 8 inch sub - hence good for bass, not clarity. Would probably be ok if u had nice splits (ive never tried/heard this before though). At least you'll save on weight and space. But to get to the full potential of good 6x9s you'd need to run them off an amp though. The head unit will probably underpower them.

But then again, in audio it all depends on how deep you wanna go into it and how picky your ears are. ie: no point getting $800 splits if you cant hear the difference between $400 splits - some ppl can, some cant. Do what sounds good to you. Hope that helps. btw, when ur testing out spkrs on a demo wall, listen out for differences between spkrs on the same setup, same song cos they will inevitably sound completely different when installed in ur car.

Link to comment
https://www.sau.com.au/forums/topic/33728-audio-dummy-here/#findComment-678042
Share on other sites

Thanks guys, I'm taking your advice and holding off on the Amp & Sub till later.

For now I'm going to get some good quality front & rears.

Head unit is a Pioneer DEH-P2050 45x4.

The current rear speakers may still be stock, Clarion 30Watt's? (Sound better than the fronts ATM)

And the fronts I'm unsure, but there yellow.

I know how to access the rears but how do I access the fronts, I have to pull off the door trim right? But how?

Link to comment
https://www.sau.com.au/forums/topic/33728-audio-dummy-here/#findComment-679356
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • To be fair passengers who aren't silly and have been in proper fast cars have often been pretty impressed once you hit 4th gear   
    • I suppose that's true. Barring almost any situation, I'll never sell so what the market does is kind of irrelevant to me. It's possible I'd make most of my money back. That spreadsheet I mentioned? Maybe I could make back more than what the car's total costs thus far are, but the parts and all that is possibly a different story... Thanks for reading. It was certainly a good moment and just makes the ties to the car that much stronger. It's exciting that the option will be there to bring it over, however I have some plans with a shop that may end up keeping the car there longer, not sure. Coupled with the fact I want to move there and haven't solidified any path yet. So in a way, it feels like I'm in a limbo state that is uncertain; time will tell.
    • No worries, everything worked out in the end. I just wanted to make the point that it doesn't matter where it comes from (I.E Australia), it can be broken or improperly built. I would still purchase from these companies in the future. B2R - Not certain how that finished, this was on a car I wired a few things and street tuned. I know the owner ended up shipping the motor back to Australia for investigation. Hopefully some of it is covered under warranty.  Turbosmart - I always pressure test everything that goes on my car. It's a habit from my career in oil and gas. I run two 40mm's and both had major leaks from the actuator to exhaust portion through the shaft. I returned both, they shipped me back two and one was leaking and the other had a 38mm top (40mm gate with 38mm actuator cap, no idea how that happens). Eventually after a lot of back and forth I found myself with two non-leaking gates. I believe this happens a lot more then people would like to believe but you would never know if you don't pressure test them prior to installation. Crank Motorsport - Issued a full refund and let me keep the seat rails. I turned them into scrap metal for other projects. GKTech - Shipped me out a replacement and asked that I modify it as per my idea and that they would do the same for a future revision. ATP - Can just needed a large shim to bolt up properly.  Haltech - They started an actual proper Beta channel for firmware's a few months back and stopped using the general public for testing. I'm now much happier.  Speedtek - f**k Speedtek. I would love to watch them burn.     
    • I've got a Turbosmart wastegate, ATP catch can, many GK Tech parts and Haltech everything. Everything's been perfect, sorry to hear your experience wasn't the same
×
×
  • Create New...