HELP! Boost controller install

[williamc]

Hi,

Need some help on an install of HKS EVC III. Its the HKS electronic boost controller.

My current setup also has HKS SSQV blow off and HKS type S intercooler. Currently I have a 2 stage bleed valve (one tap in engine bay i never use) and one in cabin.

NOW... firstly just installed the FMIC and there is a outlet that I have plugged on the intercooler pipe for a hose... is it for boost controller or blow off or both?

My blow off is installed near the plenum, with one hose coming from top with a tee that the in cabin tap goes too. There is then another hose from the bottom of blow off leading somewhere, i dont know, i think back into another plenum hose.

There is another hose and tee piece where the other tap is down the front of car near air filter which attaches i think to the waste gate actuator.

How do I remove the manual setup and where do the 3 hoses from the HKS solenoid unit go????? Obviously 2 of them will go where the manual tap setup was connected ie plenum and actuator, but the 3rd?

Shall i run a hose from the blow off straight to the intercooler pipe outlet that I have plugged??

Any help is much appreciated...

[nitemare5]

here's the evc III manual, should sort out your problems. GL.

http://www.scuderiaciriani.com/rx7/HKS_EVC..._III_manual.pdf

[williamc]

Hi,

Thanx for the manual, Ive had a look at it, but still unsure of the right places to hook up the hoses. Does anyone have any pics of where they have hooked them up?

Thanx

William

[nitemare5]

one goes to the charge pipe (the nipple on the intercooler pipe), one from the pressure source (just t-piece a plenum vacuum hose), then the other is to the wastegate actuator (hat looking device next to the turbo). The manual should tell you which of the 3 nipples on the solenoid goes where.

[williamc]

Sweet, thanx mate.

Ill give it a go tomorrow.

What do i look for to make sure that it is all OK, once I hook it up....

[Mase]

i installed my blitz ebc and it keeps wanting to not hold boost and go sky high, im hoping that the vacuum lines are just leaking.

[nitemare5]

to check, make sure all the hoses are on tight then start the car up and run through the diagnostics in the manual. should be all easy after installation.

[williamc]

Thanx, well saturday will be the day... ill give it a go then.

Thanx again

Will