Jump to content
SAU Community

Recommended Posts

changed to another 2nd hand alternator and no luck....

is there a way i can test the alternator of the car? i could have just bought another dud alternator....but want to be able to rule it out...

Hi all,

i fitted a brand new battery this morning, turned her over and all was fine.

not 30 minutes later i tried to start it again and it was flat.....clutch started it and drove off. about 10 minutes down the road the car started to choke....the revs began to bounce and within 30 seconds the car cut out.....i pulled over and tried to crank it.....flat.

i pulled out a charged battery and jumped started it.....disconnected the jumper.....and fine for 20 seconds......then revs started to bounce again....then cut out again....

i swapped the batteries....and the she started fine and ran ok......i then disconnected the battery as i didnt want it to drain again......i was then able to drive the car for 10 minutes home....

i noticed on the way home that the battery light in the dash was on.....firstly what does that light mean? and what do you think i am faced with?

im thinking alternator is cactus....but why?? nothing has changed since i drove it last....

also i just changed front bar....could the fog lights, even tho they are visibly off, somehow be on and sucking power? nothing else has changed....

list of things i need answered...

1. what does the battery light in dash mean?

2. could it be my alternator?

3. how hard is it to change an alternator?

4. fog lights?

thanks guys!!

where is u locate..? if u near by me i will come and have a look. if u like. let me know any way

  • 1 month later...
  • 3 months later...
  • 1 month later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Latest round of updates on the car. I purchased and installed a SWS clutch slipper to help with 60ft times and got some second-hand good condition 275/40R17 Hoosier DR2 radials. Test and tune in November showed the tyres were an upgrade over my over 15 year old mickey Thompson's and I got a 1.8 second 60ft and pb et of 11.71 but even then, that run wasn't great due to rain and driver error (the event got called off 10 minutes later fast forward to the weekend just gone 25th of Jan and there was finally a break in the weather to let racing happen. The first run the track was slippery and only managed a 12.1@129 Second run the track was better and got a new pb et and mph: 11.54@131   Lith and I then worked out that I installed the previously mentioned clutch slipper incorrectly and its never been working, and I had just been dumping the clutch the entire time, we also noticed it was on street boost and not race boost. So I lined up for a third run with the car turned up in the first two gears, but the passengers side axle objected to clutch dumps and left the chat which stopped my weekend.   so there will be another attempt in the future once I replace the tyres as they rubbed and are stuffed now. but a low 11 should be on the cards.
    • Ceramic coating and heat shielding, you mean?
    • Turbos don't require pulling the motor apart so that's "easier". I would recommend the Nismo R3 turbos instead if you want to do stock twin turbo. It doesn't make as much power as the 2530s but it's only like ~50 whp off the mark and should have better response (ball bearing CHRA, slightly smaller turbo). A local that went with a Garrett G30 and 6boost manifold recently nearly burned his car to the ground after the hood insulator started melting and and burning so if you go single turbo I recommend doing a lot of research and validation work to make sure you don't do the same.
    • New rear lights, filler panel sprayed, cleaned and back together    before, during, after shots 😍
    • 100% is gyprock, I agree. Slip of the keyboard. Haha! I left my indicator bulbs out to save a bit of weight.
×
×
  • Create New...