Jump to content
SAU Community

Recommended Posts

hey all,

just picked up my car from being tuned.

have put a forged 25 into it and running a gt3076r with the .60 front and .82 ext gate rear.

high mount manifold with a 38mm gate running off it.

fueled by a gtr lift pump fot surge tank to 044 external.

740cc injectors

tomei poncams, gtr valve springs.

afm is a z32 which is now located in the cooler pipe infront of the plenum

plazmaman plenum with stock TB

now i have it running on e85 and a eboost controlling 15psi flat.

i made 282rwkw.

i previously made 279rwkw on 16psi on bp98.

my question is, should i see better results than this?

i know the plazmaman and poncams wont give me more figures but better low down/mid range.

your thoughts?

Link to comment
https://www.sau.com.au/forums/topic/338436-got-my-car-running-e85-gurus/
Share on other sites

  • Replies 61
  • Created
  • Last Reply

Top Posters In This Topic

E85 generally should see 30-40rwkw gain on most street style setups.

That's the gain I've seen across what, 30 or 40 cars now and seems about "norm".

Either way though you need more boost in there, a 3076 isn't doing much @ 16psi on a 2.5ltr. 20-22psi is when the show will start.

E85 generally should see 30-40rwkw gain on most street style setups.

That's the gain I've seen across what, 30 or 40 cars now and seems about "norm".

Either way though you need more boost in there, a 3076 isn't doing much @ 16psi on a 2.5ltr. 20-22psi is when the show will start.

I concur, which doesn't normally happen with me and Nismoid...

15psi is rather homosexual for a built motor, its weak sauce even for a stock motor

hey all,

just picked up my car from being tuned.

have put a forged 25 into it and running a gt3076r with the .60 front and .82 ext gate rear.

high mount manifold with a 38mm gate running off it.

fueled by a gtr lift pump fot surge tank to 044 external.

740cc injectors

tomei poncams, gtr valve springs.

afm is a z32 which is now located in the cooler pipe infront of the plenum

plazmaman plenum with stock TB

now i have it running on e85 and a eboost controlling 15psi flat.

i made 282rwkw.

i previously made 279rwkw on 16psi on bp98.

my question is, should i see better results than this?

i know the plazmaman and poncams wont give me more figures but better low down/mid range.

your thoughts?

Same Dyno? Seems about right for that turbo and boost imo

are the injectors holding it back from more boost? ( i don't know a great deal about E85 , i'm asking because i'll be building something similar)

Exactly, I wouldnt think 740cc injectors would be holding you back! Joeyjoey... has 320rwkw with E85 on 555cc injectors (pretty sure anyway). What duty cycle are the injectors running at?

i didnt ask % but he said theres a LITTLE room to play.

i did ask for a SAFE tune, and i emphasized the SAFE...

i think afr's are 11.5 ish?

i forgot what the sheet said.

Ye i was gonna say also 740's shouldn't be maxed out @ those power figures regardless of a safe tune or not...

AFR's for E85 is not the same as AFR tuning for PULP.

11.5 is ridiculously conservative.

Ye i was gonna say also 740's shouldn't be maxed out @ those power figures regardless of a safe tune or not...

AFR's for E85 is not the same as AFR tuning for PULP.

11.5 is ridiculously conservative.

So you're saying for e85 AFR's of 12 flat are quite conservative?

What's a good AFR to tune for with e85?

12-12.3 is what a friend of mine tunes E85 at, and by no means is that 'on edge' either.

Apparently much either side of that and it doesnt go so well anyway.

11.5 is certainly on the side of really safe - its probably even perhaps possibly why power is down, a built motor shouldnt be sitting there IMO.

not even that. e85 loves being rich, seen heaps of cars make more power going richer. most recent one that comes to mind was an R35 that kept gaining power as it was fattened up near 10:1 (on a lambda scale calibrated for petrol obviously). i *think* with E85, EGT's come into it more. its not balancing A:F ratio and hp, but EGT's sort of make it 3 dimensional if that makes sense?

not even that. e85 loves being rich, seen heaps of cars make more power going richer. most recent one that comes to mind was an R35 that kept gaining power as it was fattened up near 10:1 (on a lambda scale calibrated for petrol obviously). i *think* with E85, EGT's come into it more. its not balancing A:F ratio and hp, but EGT's sort of make it 3 dimensional if that makes sense?

Mine blows the spark out at 10.5, although I am running 1.1mm gap on the plugs. No black smoke of course but a strong ethanol smell, and im sure its not good for the cat I just put in. (for some stupid reason)

Remember there's more oxygen in the fuel, so rich should still make good power.

12-12.3 is what a friend of mine tunes E85 at, and by no means is that 'on edge' either.

Apparently much either side of that and it doesnt go so well anyway.

11.5 is certainly on the side of really safe - its probably even perhaps possibly why power is down, a built motor shouldnt be sitting there IMO.

True, 12+ is fine. i tune in lambda though so 0.84 on E85. We have found atm that pump e85 is a little more like e75 so we fatten it up abit we are seeing a 0.5-0.7 jump in afr or 0.05 lambda towards LEAN when refilling with e85 so be aware.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
    • Yeah, my offer was more to show exactly how rough and ready the rig can be and still be useful. Youtube vids will definitely show cleaner setups. Same concept though.
    • I would guess the seal has gone down at the speedo drive and gearbox oil has crept up the drive cable sheath and fouled the speedo head.
×
×
  • Create New...