Jump to content
SAU Community

Recommended Posts

Hey there everyone..

Im currently in the process of ordering a set of 18" WORK VS KF'S

Im thinking about putting 18x8.5 on the front and 18x9.5 on the rear.

The car has standard guard (non-pumped). The car is decently low and im looking for someone's help...

Is there anyone that would know the right sizes and offsets that would be suitable to get max dish and offset to suit my car....

I would really appreciate someones help where as i've always struggled in this department...

Thanks guys....

Link to comment
https://www.sau.com.au/forums/topic/339168-r33-gtst-wheel-offset/
Share on other sites

+12 - +15 for stretched tyres

+22 mildly stretched

+30 for wide tyres

DONE

thanks buddy

Most appreciated.......

I'll prob go a midly stretched tyre

Would that be +22 front and rear you think...?

What width wheel front and rear would you recomend???

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Diagnosing with and without is mostly the same. You need to know, as Duncan asked, and what conditions. Car hot, cold, idling, driving, if while driving what rpms, is when you're varying, or is it when held constant.   From there it's understanding what can be causing it. Starting with pretending all of the sensors are correct. Which means if it's going rich, why would it be thinking more air is going in than it is, and under what conditions. So things like if only when under boost, it could be be a loose intake piping joint. It's just understanding the system, and understanding when/how the problem occurs, and then if it's only occuring in specific scenarios, what can be causing it.   ECU specifically, if it's aftermarket, it'll have software you can use, for the Skylines on factory ECU, there is Nissan Consult you can use. Most ECUs have a way to get data from them.
    • How do you go about diagnosing ecu's that don't have data logging, is it more experience at that point and just trying out things that you think will fix the issue?
    • Stock O2 are basically useless beyond anything at stoich. Any misfire will also be seen as lean. The stock O2 also read a collective exhaust gas volume, not each cylinder. Sputtering and missing means not each cycle is firing, and some are. Which means even if rich, as shit, on cylinders as they miss, they'll read lean, but the cylinders that did fire will read rich, and combined, well, they can read anything from rich to lean.   Start with the basics before even going looking at sensor values.   Edit: I say the above, and that's coming from the guy with a few thousand dollars worth of scan tools sitting right beside me right now that I use frequently for my job.
    • I just finished up a manual swap and I have a 1999 S2 AWD automatic in my garage, depending on where you are located. I'm in the the midwest of the US.
    • I’ve heard it can be done, you need to redrill the holes where they bolt to the chassis and apart from that they are the same. I’ve never done it or know anyone personally that has, it’s just something I’ve heard 
×
×
  • Create New...