Jump to content
SAU Community

Recommended Posts

I've not been past Kambah to have a looky, but Pat checked out Nicholls (northside servo) not long ago, and they said there was an engineer out there checking out the pumps to make sure it'll be all good.

Exactly. Haven't plenty of people including Trent (STATUS) mentioned you won't gain any more power past a certain point of ign timing on an E85 mix anyway? If you're running it in a street car, particularly a daily like mine, conservative tuning is the way to go. Go close to the edge with 98 mix, then back off the timing (particularly up top) and add a touch of fuel. Would rather feel the torque from E85 than see what kind of top end figure I can pull.

ill have to check a few things about it problem with my setup (apart from the need for additional pumps) is my 1000cc wont cut it lol would be fun to have a gt42 on street tuned 30psi though haha not sure if the motor will last too long though haha

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi all,   anyone know where I can pick one of these up for a reasonable price? I just resprayed my rear trunk due to fuel stain and my new muse spat install.    added a photo for some content 🤣👍   thanks 
    • Consider a 35 too...
    • He's right ~ there is no 'magic' with stuff like this ... it is more likely that in the process of looking for the short, the loom/wire 'incidentally' got moved in the process, thus removing the short ~ now, that maybe a wire (in a loom) rubbing against the edge of some grounded metal, that's worn through the insulation, causing the (now intermittent) short to ground. If one wire in a loom has been damaged in this fashion, it's reasonable to presume that other wires beside it may have also be damaged, and now exposed...you can bet the green crusty copper corrosion will start... ...that'd be a pisser, Murphy's Law steps right in as GTS observes...but worse, something like that is easier to find when shorted...ie; unplug bulb and fuse, and put multimeter in continuity mode so you get constant beep, and carefully poke about hoping to find if some movemet of the harness stop the beeping.... ...it's still all a bit Arnie tho' ..It'll be back... 😃
    • Yeah, but knowledge of one wire's insulation worn through to short on earth implies the possibility of other wires doing the same. I had my power steering die, because the wire that runs to the solenoid valve on the rack runs in the same loom as the power wire for the O2 sensor. And when the O2 sensor/wire did something stupid and burnt part of that loom to death, the only indication was the shit(ter) fuel economy and the heavy steering. It took deep excavation of the looms in the bay to find the problem. Not wear through in that case, but similar shit.
    • Ah, I thought he'd wired it to one of the spare ECU inputs! Too long ago since I read that post, ha ha. I've been arguing with radiators, harmonic balancers, alternators and rust since reading it.
×
×
  • Create New...