R32 Exhaust Height

[Lonewolf1983]

Thinking that my newly installed exhaust is sitting lower than it should...

Does anyone have a pic of their exhaust (in particular the section between cat and rear axle) with a mid muffler/resonator?

Would like to compare!

[Lonewolf1983]

no one has a pic of their exhaust?

[CanadianGTST]

Thinking that my newly installed exhaust is sitting lower than it should...

Here's mine. I'm on standard shocks with HKS lowering springs. No cats or resonators, the "hump" is a little bit low, but I've yet to drag it on anything. Speed bumps are fine traveling slowly. If I was any lower it'd start scraping.

If it matters, 3" dmax downpipe, 3" jic testpipe, 3.5" xspower (ebay) catback. I suspect a properly made exhaust (IE: Not ebay brand) would be much better, I've seen cars here with similar diameter cat backs that didn't go nearly as low to the floor. They were either custom jobs or properly made Japanese exhausts.

[Lonewolf1983]

thanks....

Mines a decent brand (Kakimoto), so Id have thought that the fitment would be a bit higher than it is:

There looks to be 10-20mm of room for it to go higher, i guess I can just get the hangers bent a little to make it sit higher?

[Lonewolf1983]

anyone else?

[heller44]

I managed to raise mine by reworking the hangers.. didn't want to lift the car back up so exhaust was the only option. Went from 65mm clear to 110.

The lowest point was as it went past the diff cradle.