Jump to content
SAU Community

Recommended Posts

Hi People,

All items located in Sydney - Epping.

Post ok if buyer organises OR can deliver certain items

Contact any time -

PM on here

Cris - 0403491735 Call or sms

Adrian - 0413208919 Call or sms

Photos on request - inspection welcome any time!

WE NEED ALL OF THIS GONE! NO REASONABLE OFFER REFUSED!!!

Willing to trade for items of interest including (cash either way depending on item and condition) -

Front facing RB25DET intake manifold.

Bride Seat + Rails.

R32 Half/Full Cage.

Wheels of interest.

Genuine GTR front bar cover.

RB25DE SII

Complete engine in great running cond.

Came off a Stagea.

Comes with manual R33 ser2 ECU.

Comes with front AWD diff - You can change to RWD very easily and sell the FWD diff.

Never skipped a beat, ever.

Only top fluids used.

Regularly serviced.

Did a compression test before removed and showed to be very healthy engine.

$700 ONO

RB20DET Head

Complete head, has a small weld on one side so selling as is for cams, cam gears etc

Must go, need the space!!!!

$150 ONO

R32 GTS4 Front Diff

Comes complete with sump assembly and diff housing.

4:3 ratio!! Perfect for lowering your GTR diff ratio

Working perfect when removed from car.

Barely used as car has been often run in RWD mode.

$500 ONO – MUST GO!!

RB25DET Block

Needs oversized pistons - been bored out

Bores in good condition, no scoring etc.

Comes with everything except pistons.

$100 ONO – NO REASONABLE OFFER REFUSED!

R32 GTS4 Manual Gearbox

Reasonable condition.

Comes complete with transfer case

2nd gear has usual R32 uneasiness to shift into when cold only.

4th gear had a little bit of a crunch when shifting into at high RPM, otherwise fine in normal conditions

$400 ONO

R32 5 Point Roll Cage

Alloy.

Great fit.

Very light

Painted black

$300 ONO

R32 4door aftermarket (fibreglass) rear bar

Unpainted.

Small chip on corner edge near wheel arch.

$200 ONO

R34 Front Cradle + Rack

Very Good condition

Offers

R32 Motorised Lower Lip

Motorised lip that lowers above a certin speed.

Or you can lock it down to make your car look more low, and raise it when need be, driveway, speed bump etc.

Comes with everything you need, motors, lip etc.

Offers - NEEDS TO GO!

HKS Style SSQ BOV

In Fully hektic chrome.

$50 ONO

GTR Fuel Pump

Comes complete with sender and everything. Bolt in job

$75 ONO

GTR R32 Intercooler

Slight damage to a couple of fins

No leaks

Will hold boost no probs

No restriction to airflow

Offers - MUST GO!!!

R33 Airbox

Complete

RB25DET

$200 ONO

GTR R32 front drive shaft - From transfer case to front diff

x2

Worked fine

$50 ONO

Stock GTST Fuel pump

Complete.

Worked fine.

Direct bolt in.

With sender

$20 ONO

Stock Turbo exhaust manifold

$20

Clutch Fan with clutch coupling and R32 fan

Worked fine

$80 ONO

Air Conditioning Compressor

Worked fine

$80 ONO

Space Saver Wheel

Heaps of tread

Un used.

Brand spankers

ANY offer

Alternator

Perfect working condition

$50

Attessa pump

Worked fine.

$50 ONO

R32 GTST/GTS4 fuel tank

+ Tank straps

Been slightly pushed in but NO LEAKS

$20 or a case of beer. - Preferably not a $20 case of beer :blush:

I'm interested in the space saver wheel.... I'll give you $50 for it plus postage.

PM me if you're interested.

Hey Cris

I might ring you about this tomorrow, but do you have your old GTS4 4wd tailshaft? As I assume your running a rwd tailshaft now? I am in dire need of one.

thanks

  • 3 weeks later...
  • 2 weeks later...

hey there i was woundering if u hav any pics of the R32 Motorised Lower Lip at all and how much would it b to post it to adelaide

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Getting Dangerously close to being ready to go back in the car. Rockers in with clearance castings now (and a quick check with the USA for the torque settings for the larger custom bolts) Covers and ported FAST Manifold sitting on there. Not fully tightened down as there's some clearancing required for the water pump with the earlier LS1 water pump styles. Example of the clearancing needing to be done: The body has to be ground a little but I'm struggling finding an actual piece of it. The later variant of water pump resolves the issue as the manifold was designed around it. It only came on the VZ LS1 in Australia, it got a different pulley for Gen4 motors. (it also costs $450... vs... $0).
    • https://files.fm/f/5atwkuvcjd
    • Doing some height adjustment on front suspension on a v35 and noticed this. The passenger side looks correct. So wondering what's happened to the drivers side?
    • Oh...I have the electric mirrors as well iirc ...they're in the same state as just about every other R31 door mirrors, with the 3 plastic screw towers broken/cracked in the plastic molding. All the interior is 'dry', so the mirror switches etc likely all work fine. Some pics below of the trimmer pieces ~ looks to me like previous owner, painted chrome finished trims with black paint ...ergo, the chrome underneath is likely a-ok... ...starts to look yukky posting stuff like this, how much did it cost in fuel on your last sortie up this way?...me just thinking aloud, borrow someone else's 4cyl to cut costs, come do your own pick'n'pull like before to save me some bother...hehe.. but whatever, I'll just earmark bits I know you want, because the way this is all panning out, I'll be able to retire the R31 from daily duty at long last, replacing it with a Subaru wagon I'm lining up in the wings...ergo, my attitude towards the donor pinny shell is starting to wane a bit, and I'm more than happy to help you out there... Like you say though, no rush...and I'll guarantee we won't be moving too far from this locale at any rate 😎
    • Cool, I’m just down Sydney today. Not much time to get online.
×
×
  • Create New...