Bee*r Limiter With Microtech

[I8EE]

Hi Guys,

recently hooked up my microtech, but i want to put my Bee*R back in.

the microtech has two wires going to the CAS do i just bridge off these?? i know that the microtech reads the crank angle and adjusts so i cant just cut these wires. will the bee*r still cut??

Thanks

[DVS JEZ]

How did the bee r normally get wired in? Did u have to cut the cas wires before?

[bubba]

Wouldn't the Microtech have the ability to ign cut like the BeeR does?

[bozodos]

they apparently do, bit AFAIK, it's a fairly complicated process to set up

[talky]

perosnaly i wouldnt bother wiring up the beer rev limiter do more harm than good from what ive herd

[Dobz]

Bee*R limiter is a waste of time because microtech has a soft and hard cut limter, if you don't have a hand controller find someone who does and adjust it.

[I8EE]

thanks guys, ill check out the settings through the hc, any ideas what its under??

[Dobz]

When you turn on you car the controller will come up with the normal data screen.

Click the up arrow three times and it should take you to a screen that says "Opt mix trim", once you're on that screen use the left or right arrow buttons to cycle through the screens until you come to the screen that has "Opt revlim" and the rev limiter value next to it.

To adjust it press the red "mode" button once and you should see the number 30 on the screen change to PG, then you can use the up and down arrow buttons to change the rev limiter value. Press the "mode" button again and the PG should turn to 30 again and you're done.

The hard limit is one screen across from "revlim" and its called "revcut" and you adjust it the same as above. Set it about 400-500rpm above the rev limiter, the "revlim" function doesn't completly hold revs back it just makes the ignition stumble a bit to warn you to change gears so if you have no sympathy for you engine and hold the boot in you will hit the rev cut.

[PM-R33]

Perfect explanation.

I had the soft and hard cut set up about the same (500rpm before limiter).