Jump to content
SAU Community

Recommended Posts

hey guys,

i have a general question and not sure if this is a common issue or something i need to address but when my car is idle (after driving) it sounds like i have a rattle under that car, only until i have my foot on the clutch does the noise stop and when im driving.

Any ideas what it is?

Thanks in advance!

Link to comment
Share on other sites

A multi-plate clutch would be noisy with your foot on the clutch when theres no clamp on the plates & they're rattling around. Mine is...

Sounds like you have a noisy cluster-shaft bearing. It is located in the sandwich-plate of the gearbox. Common Nissan problem

Link to comment
Share on other sites

Replacing the standard dual mass flywheel will rob the driveline of noise dampening. I have a lightweight flywheel with a JB single plate monty - noisey as all hell. Its the farkin worst... Much worse with aircon on too...

The dual mass flywheel may have been replaced in yours at some point in its history. Either way don't stress, very common, and it wont be bearing related.

Link to comment
Share on other sites

yeah it's not the clutch rattling. it's the gearbox. when sitting in neutral with your foot off the pedal the input shaft in the box is spinning and the getrag's vibrate like all buggery with a nice thwacka thwacka thwacak noise. just part of 34 GTR enjoyment I'm afraid. and yes it can happen with stock cars but usually the dual mass flywheel (standard) takes care of most of it.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • I am currently going this route. I am curious how much horse power you put behind the cut bell housing? Collins was telling me I am going to crack it and bluh bluh bluh. Because I didn’t buy the custom fly wheel from him. I am looking for somewhere around like 500 hp
    • Forgot to mention that these are the before pics when I first got it!
    • Thanks @PranK for the updated member status, much appreciated! 👍🏼 Now, about those pics… Unfortunately I could only find ones that I took in the dark. I was soon to discover that underneath it wasn’t in the best shape, but it was mine and that’s all I cared about at the time 😆
    • Oh, and only having done this task yesterday, I've now driven the car ~60km since, and while it is hard to avoid placebo effect and confirmation bias, I reckon that some annoyances I had with the way the car has been behaving have improved. Which....kinda makes sense, I guess. If the bushes were really stiff and resisting rotation, they would have been contributing to the effective wheel rate. And if it was more so on one side (which it was, because one side was worse than the other) then.... you might imagine that the additional rate would be asymmetric, and potentially even different between compression and rebound. And so... the car has been twitchy at higher speeds - like freeway on ramps. It really shouldn't be. The wheel alignment is good and there are no (other) known problems elsewhere in the suspension. But at 90-100 on a long sweeping ramp, tiny steering wheel motions would make it feel like it wanted to rear steer. Quite nervous. At lower speeds it would heave about in a manner that it didn't use to. Didn't want to put power down, etc etc. Now...seems to behave better. Am going to have to concentrate on the various corners where it has exhibited weirdness, on the rare occasions when I can get a decent run at them without Methanial getting in the way in his D-Max/Ranger/LDV Van/etc.
×
×
  • Create New...