Jump to content
SAU Community

Hks Evc Ii

iplen

By iplen,
in Engines & Forced Induction

 Share

Recommended Posts

iplen Mentor

iplen

Posted
Posted

As per the title, my car has a HKS EVC II in it, I have tried downloading the instructions from hksusa.com but it is not happening, done a search on here with no luck, so

A) Does anyone still remember how to adjust this unit?

B) can you tell me how?

Thanks in advance!!

Link to comment
https://www.sau.com.au/forums/topic/344909-hks-evc-ii/
Share on other sites
iplen Mentor

iplen

Posted
  • Author
Posted (edited)

Thanks, but the one I have is not covered there... I am imagining that adjusting it may well be pretty similar, and I will suck it and see if it comes down to it, but would prefer to know what i am doing...this is the unit,

post-26910-1290240367_thumb.jpg

Edited by iplen
Link to comment
https://www.sau.com.au/forums/topic/344909-hks-evc-ii/#findComment-5558512
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Toni
      R32 GTR - Where to begin

      By Toni · Posted

      Thanks Murray, appreciate the advice, a few things to think about now 😀 
    • Murray_Calavera
      R32 GTR - Where to begin

      By Murray_Calavera · Posted

      After my million questions, I'll throw in my 2c now.  If I was in your shoes, I would buy the best/most modern ECU available. A Nexus S3 would fit the bill. It is highly likely that this ECU will last the life of the car, regardless of whatever ECU manufacturers develop in the future. Modern ECU's are amazing and will still be amazing in 10 or 20 years time. If you can get e85 relatively close to where you live, I would buy a flex sensor and size the injectors to run e85. I'd go a Walbro 525 fuel pump with relay wiring kit.  Turbo wise, I'd hit up HyperGear and get a pair of the biggest bolt on turbos.  Now for the safety side of things, I'd have the tuner setup the tune to be very soft/safe on 98. Then on the flex tune, a lot of the timing can be put back in on the top end (I'd run full boost on both tunes, but manipulate the power with the timing). This also has the benefit of hopefully delaying the, "bored now, need more boost" that comes with owning a modified turbo car. If you spend most of your time on the 98 tune, the few times your on e85 will hopefully stay special/fun.  The bad news. As your paying for labour and tuning, I don't think this will happen with $10,000. This might be the motivation to learn to do it yourself though, that way instead you'll have the built car and change from the $10,000
    • Toni
      R32 GTR - Where to begin

      By Toni · Posted

      Cheers Duncan, on club reg and very much a weekender, don't drive it all that hard and don't intend to go overboard at any point in the future too. In my 40's and quite mature driver, just want that little bit more from it 😉 Sounds like, after ensuring everything is in good condition, ECU, Injectors, Fuel Pump and a set of turbos is likely to be my path forward. 
    • GTSBoy
      R32 Gtst - Sunroof Assembly And Roof Bits

      By GTSBoy · Posted

      15 years is not too long to hold onto something like that, right?
    • Satwinder
      R32 Gtst - Sunroof Assembly And Roof Bits

      By Satwinder · Posted

      Hey man,   By any chance you still have sunroof for sale ?   Thanks
×
×
  • Create New...