Jump to content
SAU Community

Recommended Posts

ever wondered what the small round plastic thing is at the far left side of the front windscreen demister is?

it's a sun load sensor for the climate control. when you hit econ instead of A/C it measures the direct sunlight and works hard when needed rather than just all the time.

Heater or A/C not working well?

Climate Control Diagnostics

if you turn your ignition on and then hold the off button on the climate control for 5 seconds you will enter diagnostic mode.

hit the temp increase button (red triangle) to test all sensors. if any sensor is giving wrong readings it will give you a code.

20 means nothing is wrong and 21 through to 27 will give you the sensor that is faulty.

keep in mind, you must have direct sunlight on the sun load sensor for it to diagnose properly (otherwise it assumes the sun load sensor is stuffed)

20 - all is normal

21 - outside air sensor

22 - Inside air sensor

23 - Water temperature sensor

24 - Intake temperature sensor

25 - Sunload sensor (small sensor on the left hand side of the dashboard near the windscreen)

26 - PBR

27 - Refrigerant temperature sensor

ever wanted the climate control to try harder to cool or heat?

to enter full cold mode, turn the temp down to 18 degrees then hold the cold button. (figured this out accidentally)

do the same for full heat but turn it up to 32 then hold the hot button.

ever wondered where the climate control takes the interior temp reading from?

just right of the ash tray there are little slots in the plastic. that's where.

whilst moving if you turn the ignition off and on you lose all wheel drive until you stop.(fairly well known but maybe you didn't know)

any more cool stuff, please let me know! i love finding these things out!

  • 1 month later...

Thanks for this. Very interesting. Bloody 1990 cars shoulda been make in 1997 or something lol.

Can this sort the problem of not being able to increase temp? Soemthimes I can only decrease temp and not increase (when I press the red arrow it does nothing).

Edited by TyresBro
  • 5 months later...

Thanks for this. Very interesting. Bloody 1990 cars shoulda been make in 1997 or something lol.

Can this sort the problem of not being able to increase temp? Soemthimes I can only decrease temp and not increase (when I press the red arrow it does nothing).

Just going through a few old replies I never read, this sounds more like a stuffed hot button on your climate control unit. I'd buy a second hand unit or take it to a small electronics store :) you often find one little old guy that owns it and will help with anything electronic. They'd be the two things I'd conceder anyway. Seen r32 climate control units on eBay for $200.

  • 4 months later...

Hey mate, I've got 2 climate controls, both work fine fast heat fast cold up down ect, my heater was stuck on and heater tap wasn't moving on FC so I changed it now it does, however it's still stuck on hot air when I change the heat up and down and the tap isn't moving, I think it's a sensor somewhere but neither of the units will go into diagnostic mode, any ideas anyone? Help will be appreciated cheers!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I can see between the water jacket and cyl 3 there wasn't a hard line of combustion gas. It certainly appears that the issue is coming from there. Yes, checked the tension. All at 100ft lbs where I set them 5 years ago. These blocks can crack but generally when they have been over bored. Mine is only 0.5mm oversize at 89.5mm. They break between cylinders around the 91mm mark. No sign of that with mine. My gut feeling is the head gasket lifted a while back when the studs stretched and i bandaided it by retorquing the studs. It's finally let go.
    • My Nismo 1.5 churps a bit on reverse turns when cold, but besides that feels like a stock diff.
    • Yes, but, I paid cash and I'm pretty sure the receipt was in the bin 10 minutes after I got home Note to self, keep all receipts
    • Bunnings would have just handed you your money back on that one!
    • So, version 4 intake is on its way I was looking at these a while ago but at around $200 or more it was a little pricey for something that might not work, but, I had it in my watch list, but, I got a message saying it was on special, and I had a code thingie to use, it eventually came in at $120 delivered, so BAM, BUY NOW.....LOL I'll need to have a look when it arrives but I feel it will "look" better than what I currently have, as it comes with a PCV fitting, so I will be able to get rid of the alloy pipe that goes to the throttle body with the PCV fitting  Well, that's what the voices in my head are telling me  Oh, and this happened today Yeap, it was a Trojan, and it was cheap, so I headed back to the hardware store and actually spent a little bit more on a heavy duty,  one that was actually recommended by a plumber mate, a Cyclone one with a fibreglass handle that is actually rated for clay The broken shovel will eventually be "modified" into a short handle shovel
×
×
  • Create New...