Jump to content
SAU Community

Recommended Posts

WRECKING s3 hr31 passage all parts available (hit me up with the parts you need)

i have loads of pics so msg me if you wanna see pics

-----------------

Hr31 complete front struts, discs and breaks, lowered springs (not sure what brand), strut inserts, lower control arm + all nuts and bolts to bolt up. $350

Hr31 coupe interior (front & rear seats) great condition $270

Hr31 drive shafts / axles $500

Hr31 rear cradle $300

Hr31 complete rear brake set up $160

Hr31 rear struts & lowered springs $70

Hr31 turbo instrument cluster $100

Hr31 complete 3" inch exhaust system from dump pipe to tip $120

Hr31 compete doors electric windows, switches, door cards etc (may part out) $150 each

15" inch mag wheels 114.3 stud patten with great tyres $320

Hr31 complete power steering unit $150

Hr31 chrome door trims $100

Hr31 door rubbers (seal the doors) $50

Hr31 steering wheel "skyline" $100

Hr31 boot lid $80

Hr31 complete seat belts (front & rear) $150

Hr31 complete wiring loom (engine & car) $170

Hr31 sun visors $60

Hr31 roof lining $50

Hr31 dash (black) $70

RB25DET S2 R33 ENGINE PARTS:

1 x S2 rb25det AFM air flow meter (pink label) $100 each great condition

1 x rb20det or rb25det CAS (crank angle sensor) $50 great condition

1 x rb20det/rb25det manual gear shifter $60 good condition

CAN USE AUST POST OR COURIER MOST ITEMS (AT YOUR COST) I'M LOCATED IN CHERMSIDE (BRISBANE NORTH SIDE) PICK UP FROM THERE

CHEERS LUKE

post-61812-1290422213_thumb.jpg

  • Replies 60
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • The cam I am actually putting in (a few posts up) is actually smaller than my current one. At least duration/overlap wise. All the chop stuff I hear just sounds like an engine running badly, because it is. I then envision driving it around in 1st gear and being massively sad about it bucking to the beat of said chop. There is an idle video of someone with a similar cam floating around the internet, but mine is a custom cam (so is his) so it'll never be the same, plus the fact exhausts are entirely different. What I want to do is put some bullet mufflers/race mufflers in to replace a couple sections straight pipes that currently replace the two extra cats that I don't need. But this is even further down the line!
    • I can tell you now, when the bracket that the little hydraulic ram attaches to snaps, with a subframe, and V8 from an AMG C63 on it, it sounds like someone letting shotgun off right beside you. It leaves your ears ringing, and a huge thankfulness that you never ever put a body part under something heavy that's only supported by a hydraulic lift...
    • Still not a guarantee fix. I used a high quality butyl-mastiq (the black goo that's not really silicone nor polyurethane, same stuff they use from the factory that just spreads out like melty cheese), and I still get lots of water on both sides of the trunk when raining or washing the car. I also suspect the factory spoiler rubber gasket might not be sealing well, so I'm thinking of adding a thin layer of grey silicone around the bolt holes on both sides and see if that's where it also leaks from. The biggest issue is that these cars don't come with a drain hole on each side like other coupes and hatchbacks.
×
×
  • Create New...