Jump to content
SAU Community

Recommended Posts

tested amp drain when car is off at 0.95 amps is this normal the car is more track then show and has only minimal sound equipment std. speakers aftermarket deck. It has got a power fc and bosch 044 pump. what could be my problem. i have tried a new battery

any help greatly appreciated and yes i did search and could not find anything about amp draw

start pulling fuses until the draw goes away. that almost looks like a light is on somewhere. if you are working in the boot push the boot catch closed and retest.

normal draw is 20-50mA so 0.02 or 0.05A.

hate it when the volts excape.lol

bet its a bad backup battery in the siren ?? happens after about 2-3 years or more often if you don't drive often or deep cycle the main battery?

or stuck relay ? your sure nothing is wired to be on with the key off ? aftermarket stuff ??

i think this might be the problem however i got all the kickpanel fuses out and its not loosing voltage just got to work out which one it is. car for last 2 year is old a weekender/ fortnight car

well that's easy then.

disconnect negative cable from your battery.

grab a multimeter and set the dial to read Amps - 10A.

clamp one of the multimeter leads to the negative terminal of the battery, and the other lead to the negative cable you disconnected.

Now the circuit is complete, and power is back on.

Your multimeter should be showing you the current drawn from your battery.

So with the car turned off (make sure interior light and boot light are off), start removing one fuse at a time, and check the meter each time to see if the current draw has dropped to acceptable levels. 0.05A or under.

Replace fuse, and pull the next one untill you find the one single fuse that causes the current reading to drop. whatever that fuse powers is the source of your problem.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There are several aftermarket options available, from not-too-painful moneyhttps://justjap.com/collections/driveshafts-bearings/products/d-max-reinforced-replacement-rear-driveshaft-set-fits-nissan-s13-s14-s15-r32-r33-r34-c35 and  https://justjap.com/products/crank-motorsport-billet-rear-axles-fits-nissan-skyline-r33-gts-t-r34-gt-t?srsltid=AfmBOorQk4xkGUa98kO7v2ePLUiNt-HRrM2AwWNw9mbSIVE1ujBVwY__, all the way up to The Driveshaft Shop https://driveshaftshop.com/skyline-cv-axles/
    • Yeah based on old XRC5964S specs, it looks to be roughly GTX3576R sized? But this 5964S compressor will flow 90lb airflow somewhat similar to the compressors in both the GTX3584RS or G35-1050.. I fully expected the 0.64 rear A/R to choke up top - seems way too small from typical convention - but these are seemingly beneficial over the prior 0.82 results.. Be interesting to see if he comments on the EFR question in that thread - he mentioned in a prior video that BW EFR's were the "cats pajamas 10 years ago", but by the sounds of things all his kits have been using Xona for quite a while now.
    • Yeah it’s still got the oem manual gearbox and clutch, only kinda mods are a blow off valve, coil overs, and a aftermarket intercooler. Also had it for about 2 months now with a lovely midnight purple paint on it.
    • Yeeeppp, been following a lot of the testing on the latest Xona stuff and there are some mental results.  He also went over 1000hp @ 4 hubs on his Mainline with a XRE6364S (63mm) which was also well into the 20psi range before 4000rpm on a 2.5. Crazy stuff. Fwiw the XRE5964S is basically the modern equivalent of their old HTA3582 - would drive nicely enough on an RB25 or 26, but proven capable of a huge amount of power if you want to spicy with rpm tho even at sane boost levels will make stout numbers 
    • The axels in my R33 seem tired, and have a bit of play in them. I cannot find any new of course, not interested in buying used, but I am looking to see if anyone can identify some cross compatible axles. In the states I have seen suggested for S chassis the J30 axles, however for the skyline (as best I can tell) the lengths are about an inch off (2.5cm) on both sides. R33 my measure L 22" R 24.5" GPT L 22.5" 24.25" J30 L 23.5" 25.5"  so shaft length is probably an inch wider. Not sure if someone has another still remanufactured option besides the J30. I figured worst case I can buy a pair tear them down and swap the center shaft. My other option was reaching out to GSP to see if they cannot piece together a set, since the axle stubs are still manufactured, I wouldn't think it be that hard to find a shaft or make a shaft work. 
×
×
  • Create New...