Jump to content
SAU Community

Fs Blitz I Color Near New Cheap


Recommended Posts

As much as I want to buy this, It's kinda hard to trust you.... You only just joined today and you are selling something that's less than half price. And 90% of us wouldn't be able to come check it out in person since you are in TAS :blink:

Link to comment
Share on other sites

haha funny f**ker.. not accusing you or nothing as i am interested.. but this guy was doing the same as you.. same car.. same controller swap over.. ended up being dodgy.. so confidence isnt very high LOL..

http://www.skylinesaustralia.com/forums/Fs...ml&hl=boost

Link to comment
Share on other sites

haha funny f**ker.. not accusing you or nothing as i am interested.. but this guy was doing the same as you.. same car.. same controller swap over.. ended up being dodgy.. so confidence isnt very high LOL..

http://www.skylinesaustralia.com/forums/Fs...ml&hl=boost

And he drives the same car too? haha

It seems like it every VL turbo comes with a bonus i-colour but they all still wanna change to eboost 2 lol

Link to comment
Share on other sites

whoa.. actually i beleive you are the same person.. both from tas.. apologies if you arent..

EDIT: well i have reported it to the Mods for IP check.. If he isnt then i fully apologise.. But it's all such a coincidence.. I would do COD on this only..

Edited by .:: GimpS-R34 ::.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share



  • Similar Content

  • Latest Posts

    • Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
    • If the car is legal height I can't see it being an issue. Found a thread on reddit that might offer some insight.   I got a ticket from a copper in QLD for my S15 being too low. They had this wheel thing on a stick that they put under the car and it hit my exhaust. Anyhow went to an exhaust shop to get the exhaust tucked up/hung a little higher and I wound the coilovers up a smidge. Don't think I even had to go back to the police station unlike when I got defected for having a carbon bonnet when I brought the S15 from the ACT to QLD and had to replace it and then rock up at a police station and have a yougish female officer who knew nothing about cars confirm that I had changed bonnets. Should have just painted the carbon bonnet yellow to match the rest of the car lol
    • Id like to race in the US i think alot of those track would suit me   For the s15? Youd be stuck between club sprint and the new Open Am wouldnt you depending on how much interior you have left in
×
×
  • Create New...