Jump to content
SAU Community

Recommended Posts

Finally after 4 and a half months my car is where it belongs. A bit worse for wear though.

The repair shop apparently couldn't be fu**ed to turn a key and then turn it again ten minutes later like I asked them to so the battery had drained. The computer seems to have reset itself along with the electronic boost controller which is beeping like a bi**h everytime boost comes on.

Back home again and this is where it all came unstuck. Reving it past 3K was impossible. It'd start backfiring and blowing black smoke like it was the Sydney bushfire all over again. I nearly choked on the petrol fumes. Mind you the petrol in her is over four months old so that can't be helping the situation.

Atm it's undrivable so I have to get her towed and tuned. I will demand they pay for this expense as it was their incompetance that got it to this state.

A couple of questions if you're still reading... Does the PFC reset if the battery drains and does it retune (learn) itself or do I have to tune it all over again? How does the petrol's age affect it? What is causing the huge amounts of black smoke that could choke an elephant?

Final word of thought, be careful and insist on idiots like the ones that fixed (???) my car, to turn it on every week and replace your petrol before you drive it.

Link to comment
https://www.sau.com.au/forums/topic/346-shes-home-and-shes-sick/
Share on other sites

george I sympathise I have n't had my car on full song for a couple of months and to see people take for ever and barstadaise my car like that I would be very angry.take it some where and get it retunned I would also be checking there is nothing wrong visibly in the engine bay. they might have got water on the afm or something. I hope all is well I can t wait to get my car back and then get the r33.

cheers

meggala

Atm it's undrivable so I have to get her towed and tuned.[/quote:8646269995]

Not that you'd be driving her anyway...RIGHT? must...resist..... hehehe

nah seriously, that sucks, they sound like they don't care about cars at all! It's not too much to ask to have a workshop treat your car with a bit of care and respect!!

Good luck with everything :)

Know the feeling George, only difference in m yscenario is that I appear to be the one at fault :x My battery is now totally drained and decided it would leak acid all over me, my garage on the boot of my car when I pulled her off to take it and have it recharged. A battery less than a month old should not do this right ? :roll: I'm looking for the receipt like a madman

i couldn't resist. after 4 and a half months i had to drive her around the block a couple of times. it's impossible to resist :twisted:

took the rocker cover off after fighting with it for 15 minutes. the plugs were platinums and they were burnt and had deposits of oil. also stank on petrol. bought new coppers with urmines help. i was going to drain the fuel tank and line but i thought i'd best take it in for a service. don't want to take any chances.

Onarun. When you cant rev past 3 grand and you blow heaps of black smoke then your Air flow meter is gone. That are the symptoms of a dead AFM and the reason why the engine does that is to run extra rich and protect the car as it doesnt get any signal from the AFM and it needs to protect it by going into limp mode.

Guys (and Shell)

I got my car out of the crash shop yesterday with fresh paint and panels, when they took it off for a wheel alignment, a heap of blue smoke came out of the exhaust. Any ideas anyone?

My theory is when I had my stack the motor shut off straight away making the turbo cook letting oil past the seals? Read ->stuffed

The battery was dead as well, try getting one of those suckers out with the strut bar in place :?

a heap of blue smoke came out of the exhaust. Any ideas anyone?[/quote:2fbb44f0cf]

There's some basic things you can tell about an engine's condition by the colour of the exhaust emissions ... blueish tinge - usually oil.

The battery was dead as well, try getting one of those suckers out with the strut bar in place :?[/quote:2fbb44f0cf]

Hehe, had to do it yesterday. Try getting one out past the strut bar, having acid all over your hands, your boot and your garage floor .... things been in there a month and it's now dead as a door nail. Not sure if my alternator is gone or if I have something using power when the car is off. Brand new battery though and even my battery charger wont charge it as it seys it fails to hold a charge.

JiMbO,

The motor's still in good nick and with these wintery days I managed to wind it off the clock easily on a back road this arvo.

If I wasn't at the servo without tools, I would've pulled the strut bar out before changing it over. I'm not too keen on the idea of the battery not having a vent tube either. Electricals in a confined space with a lead acid battery (hydrogen) = Boom! 8O

Because some nissan genius decided to put the battery in the boot (probly for weight distribution?), the original equiptment battery was sealed with a ventilation tube running down the left hand side of the battery and through the floor. Have a look for a rubber grommet where the tube used to pass through.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Was planning on getting an R35 MAF and the adapter, should this be okay? Also any idea where I could get my hands on an intake pipe?
    • I mean yes, if you're starting from scratch on an unknown engine yes you don't need to be doing all kinds of math in the background but if you're doing relatively minor changes like AFM + injectors + boost up with some aftermarket turbos it takes quite a bit of math if you want to do something like maintain OEM fuel + timing tables but compressed and then a bit more load scale up top. I think I've spent too much time working on big engineering nightmares though so I'm a big fan of trying to constrain the scope of whatever work I'm doing as much as possible and trying to get it right before moving on. For example, a local owner just did the usual E85 + single turbo conversion to his R32 GTR and nearly burned his car to the ground doing some spirited driving up the local mountains. Turbine is unshielded and too close to the hood insulation. It's tough to balance "just get the project done" and "seemingly small details can cause massive setbacks I'm not willing to deal with".
    • No idea about Neil's steering wheel, but I have the same behaviour in the Stagea. I doubt it has ever been messed with so might be normal. Indicating to turn right at a roundabout and correcting even a little bit to the left to go around will cancel the indicator. Never considered it an issue other than it being a bit odd.
    • Does anyone know if this is off centered? Looks like it, when I indicate to go right, but turn my steering wheel slightly left it cancels (was always like that even before I started messing around with it) was wondering if anyone else has the same issue?
    • Nothing photo worthy since last update, lots of little plumbing bits for the AAC/Cold start valves, and unfortunately I still need another couple of parts for the brake booster line and the AAC into the plenum. Otherwise it all looks good to start up engine wise, onto checking the electrics/interior
×
×
  • Create New...