Jump to content
SAU Community

Wrecking R33, Rb25 Parts Cheap

TJ_R33
 Share

Recommended Posts

TJ_R33 Community Regular

TJ_R33

Posted
Posted

PM or call 0423 799 320 with any questions. Everything is ONO

RB25 Cam Covers $50 for the pair

RB25 Timing Belt Cover $25

33 Side Exit Exhaust (Great for track days) $100

High Mount Dump Pipe $50

Cam Angle Sensor $25

Malpassi Fuel Reg $40

38mm Dual Port Turbosmart BOV $150

Indicator and Wiper stalks $20 a side

33 Front Strut Brace $40

33 Radiator Air Guide $30

Cusco brake cylinder stopper $40

DSC_0312.jpg

DSC_0299.jpg

DSC_0298.jpg

DSC_0485.jpg

DSC_0481.jpg

DSC_0483.jpg

DSC_0480.jpg

DSC_0478.jpg

DSC_0477.jpg

Link to comment
https://www.sau.com.au/forums/topic/346064-wrecking-r33-rb25-parts-cheap/
Share on other sites
TJ_R33 Community Regular

TJ_R33

Posted
  • Author
Posted

Clutch Fan $50

SAAS Racing Seat $125

RPM Racing Harness $50

Rear Tailights $100 for the pair

Front Guards $100 each

Boot $75

Rear Brake Calipers $100 for the pair

Hand Brake cables $75

Almost new Pineapple Bushes $50

New Alternator $100

RB25 Throttle body $50

Also have heaps of interior bits and pieces

Alternator.jpg

StockThrottleBody.jpg

DSC_0303.jpg

RearTailLights.jpg

Pope Apprentice

Pope

Posted
Posted (edited)

Will send PM - shotgun strut brace and fan if its in good nic...also do you have dash/cluster surround trim and handbrake/gearlever boots?

Does the fan have any cracks around the circular part in the middle (or anyewhere)?

Edit - Or not, PM inbox full :D

Edited by Pope
TJ_R33 Community Regular

TJ_R33

Posted
  • Author
Posted (edited)
Will send PM - shotgun strut brace and fan if its in good nic...also do you have dash/cluster surround trim and handbrake/gearlever boots?

Does the fan have any cracks around the circular part in the middle (or anyewhere)?

Edit - Or not, PM inbox full :P

Fan has no cracks from what I have seen and both my and my mate have had a look, and I do have the dash cluster trim but not the handbrake or gearlover boots..

Edited by TJ_R33
Pope Apprentice

Pope

Posted
Posted
Fan has no cracks from what I have seen and both my and my mate have had a look, and I do have the dash cluster trim but not the handbrake or gearlover boots..

Ok sweet, will grab that as well, can you PM a mobile or email? Should be able to come pick them up. Strut brace mine?

TJ_R33 Community Regular

TJ_R33

Posted
  • Author
Posted
Ok sweet, will grab that as well, can you PM a mobile or email? Should be able to come pick them up. Strut brace mine?

Number is at the top of the page mate, when did you want to pick them up?

Pope Apprentice

Pope

Posted
Posted

Sorry, reading fail - looked at bottom of post not top :P Just tired now, will try again tomorrow at a decent time :blink:

Probably on the weekend if I can, not sure which day ATM, can prolly do either. Don't suppose you have an old radiator lieing around...mine blew on way to work today ;)

TJ_R33 Community Regular

TJ_R33

Posted
  • Author
Posted
Sorry, reading fail - looked at bottom of post not top :) Just tired now, will try again tomorrow at a decent time :)

Probably on the weekend if I can, not sure which day ATM, can prolly do either. Don't suppose you have an old radiator lieing around...mine blew on way to work today :(

I might still have my old one somewhere, I will have a look. I must have already sold the strut brace a few months ago mate cause I had a look for it tonight and couldnt find it, I could have sworn I say it the other day.

  • 3 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • tsuokun
      R34 GTT RB rough idle problem with weird RPM gauge fluctuations

      By tsuokun · Posted

      Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • niZmO_Man
      R32 gtst speedo out by 10kph

      By niZmO_Man · Posted

      Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • niZmO_Man
      Rv37 400r questions

      By niZmO_Man · Posted

      +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
    • GTSBoy
      Stock rb25det neo questions

      By GTSBoy · Posted

      Yeah, my offer was more to show exactly how rough and ready the rig can be and still be useful. Youtube vids will definitely show cleaner setups. Same concept though.
    • GTSBoy
      R32 gtst speedo out by 10kph

      By GTSBoy · Posted

      I would guess the seal has gone down at the speedo drive and gearbox oil has crept up the drive cable sheath and fouled the speedo head.
×
×
  • Create New...