Jump to content
SAU Community

Recommended Posts

Im building one in the next few weeks for a customer

I have already finished the head

It showed up as 308 hp on paul gilberts flow bench, with 85 % exhaust flow

It has itb,s on it with a turbo and an hks scavenge tank

We are just using the std cam at this point but will look at some thing else later

It has haltech going on with 550cc injectors we are looking for 350 at the wheels

What's the big deal about Horsepower?

If you're doing a big bore L28, your going to need an N42 block and be sure to have it Sonic tested to be sure the bores are thick enough after the 3.0mm over bore. The common thought is to use the siamesed F54 block, but I will be very surprised to see any F54 block capable of taking an 89.0mm bore and the N42 block has a higher silicone content.

This L31 engine has been done to bits and very well documented online, but turbo is not normally the way to go, because the bore becomes a bit thin and under high boost pressure, the bores are porous.

I'm doing an 87.0mm bore (2818cc) 380 injectors, about 250HP @ wheels and over 600Nm torque, so who needs HP.

Your going to need; LD28 diesel crank, L24E rods, KA24E pistons for your bottom end. Rods should be chromoly or H beam forged & pistons forged to KA24E specs.

Cheers, D

What's the big deal about Horsepower?

If you're doing a big bore L28, your going to need an N42 block and be sure to have it Sonic tested to be sure the bores are thick enough after the 3.0mm over bore. The common thought is to use the siamesed F54 block, but I will be very surprised to see any F54 block capable of taking an 89.0mm bore and the N42 block has a higher silicone content.

This L31 engine has been done to bits and very well documented online, but turbo is not normally the way to go, because the bore becomes a bit thin and under high boost pressure, the bores are porous.

I'm doing an 87.0mm bore (2818cc) 380 injectors, about 250HP @ wheels and over 600Nm torque, so who needs HP.

Your going to need; LD28 diesel crank, L24E rods, KA24E pistons for your bottom end. Rods should be chromoly or H beam forged & pistons forged to KA24E specs.

Cheers, D

A'MEN

........OR

buy an OS Giken 3.1L and fuel inject it and turbOOOOOOOOOOOOOOOO it :)

would i be better off resleeving an l28 and adding an ld28 crank and suitable rods/pistons? least then il no how much meat ive got left in the bores?

also what head would u reccommend?

thanks for the replies appreciate the advice

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...