Avcr Help

[lindsey34]

does anybody know where to run the wiring and plugs for the apex AVCR through the fire wall?

[neil_se]

follow the bunch of wires coming from your ecu back through the firewall. there's a hole on the drivers side too.

[lindsey34]

Thanks mate I'll give it a go.

[lindsey34]

it's so tight to get your hands in there to follow the ecu wires, dont tell me i will have to pull my dash apart to find the hole easily.

[neil_se]

try feeding it through the engine side of the firewall. there might be more room to get it through on the drivers side.

[lindsey34]

Does anyone know of any other way?

[GZ R33]

Does anyone know of any other way?

I am almost certain that when mine was installed they fed it through the drivers side wheel arch, need to remove the plastic inside and you will see two holes with wiring going from the cabin to the engine bay

[lindsey34]

GZ R33,

Remove the plastic from inside where?

[GZ R33]

GZ R33,

Remove the plastic from inside where?

In the wheel arch.

[makaveli]

when i put mine in i fed the wires through the passenger side with a wire coat hanger

it worked well

take it easy

Mark

[Mase]

mark sounds like he has the right idea. I personally wouldn't use the wheel arch one if your inner plastic guards go like mine have from running 18's on the onevia. I used a screwdriver to push a hole thru the rubber boot on the passengers side of the car (ecu one). I then fed the wires thru.

[lindsey34]

Thanks for your help everyone, I finally managed to feed the wires through by removing the glovebox, this gave me better access to the hole that the loom runs through, I got someone to lever the rubber seal up with a flat screwdriver while I fed the wires through.

[makaveli]

take it easy fellas!