Jump to content
SAU Community

Rb25Det 3" Mandrel Bend Stainless Steel Xforce Exhaust

045HOW
 Share

Recommended Posts

045HOW Mentor

045HOW

Posted
Posted

i have for sale 3" mandrel bend stainless steel xforce exhaust

3" dump with oxygen sensor

100 cell high flow cat (2 months use)

cat back exhaust

needs a clean

few scrapes under the cannon

cannon tip bent a bit on one side

asking price:400

cheers

pm me

post-76376-0-19401300-1292912074_thumb.jpg

post-76376-0-04919600-1292912083_thumb.jpg

post-76376-0-24451800-1292912091_thumb.jpg

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • pacman_1219
      Blue/grey smoke after idle

      By pacman_1219 · Posted

      Update Got turbo back from hypergear, installed everything etc. Bled coolant, wasn't smoking so I thought beauty she's sorted now. Went on a drive, car up to temp, let it idle for about 15 seconds, gave it some gas...nice puff of smoke again. Fml No doubt my turbo was pretty worn anyway but nonetheless frustrating that the problem persists.
    • Roy
      Garrett G Series

      By Roy · Posted

      Lol, yeh sure. But I'm not changing the head on this engine. Turbo is the current mod im looking at; as the VCT-2.6L  engine im building is getting the turbo setup i posted so the old built RB25DE needs a snail
    • Dose Pipe Sutututu
      Garrett G Series

      By Dose Pipe Sutututu · Posted

      New setup just needs a VCT enabled head and it will come on so much earlier. At least 500rpm of added response, if not more.
    • Komdotkom
      Alcon TA6 Calipers on R33 GTST - Flexing

      By Komdotkom · Posted

      Wow, there's a user name I haven't seen for a while! Good to see you back @Sydneykid
    • MBS206
      Question about BoV on RB25DET NEO

      By MBS206 · Posted

      Something to note, on an aftermarket BOV, it's quite possible to end up with the worst of both worlds, where on light throttle, there isn't enough force to open the BOV so you get small reversion and driveability issues, and with the venting to atmosphere, it dumps a lot of fuel on shifts. Realistically, dumping to atmosphere under power isn't a major driveability issues, compared to the issues of stalling from reversion. If you're getting up the throttle, then putting the clutch in, say on a shift up, but then don't release the clutch, yes, the engine can and will stall, but, just drive around it, and that's easy, let the clutch out in the next gear and the car rolling will keep it all running / going.who wants a hard hit of throttle and then to just let the motor idle anyway?   Main issue for driveability is blipping throttle and it wanting to stall, like when parking or trying to move in slow traffic.
×
×
  • Create New...