Jump to content
SAU Community

Recommended Posts

Installed my whiteline front swaybar today

managed to pick it up for $175 s/h with the hd links on it too

with the old one out I was a little disappointed that they seemed to be the same diameter

but the mounting points for the links are closer to the pivot (less lever arm therefore stiffer bar) and the whiteline bar is solid where i guess the stock one is hollow

IMG_20121112_143319.jpg

IMG_20121112_143240.jpg

It was actually really easy to change, i didn't even jack the car up, just moved it onto the curved part of our driveway so the nose was off the ground a bit

IMG_20121112_143516.jpg

IMG_20121112_143527.jpg

yet to go for a drive but will report back when i do

Dale, are you still selling rear bars? i'd be keen to get one of those too now i have a little bit of spare cash

Got bored this arvo so I threw one of these in my car

rQiWq.jpg

But unfortunately I've imposed a ban on driving my car until some other parts arrive, which will hopefully be this week - and THEN I can find out if it makes any difference :ninja:

Don't you have an emanage that needs to go in?

And yes, I'm aware of the irony of that comment. :P

Put your car on a dyno in case the afrs and timing are all wrong. Presumably its not the tunable type?

Its not tunable, but I doubt the afrs will be too far out. No doubt it also still runs a closed loop system, monitoring and self-tuning via the O2 sensor.

Sooooo your the one that got that! I thought it went to LEKS! Bastard! :P

haha so thats who I was bidding against :whistling: Fortunately, another quality part has come to Australia rather than Russia!

About bloody time Dunc!

I've been busy :ninja:

Don't you have an emanage that needs to go in?

And yes, I'm aware of the irony of that comment. :P

I cant do an Emanage install in 20 minutes :P

and yes, severe irony noted. You got that intake done yet? *ducks*

and yes, severe irony noted. You got that intake done yet? *ducks*

Funny you should mention that. Goes in tomorrow.

Also noticed now that the informeter is back in injectors are at 95%... Fuel reg is going in.

Spoken to the tuner too. Booked out for a month.

I haven't had my fcon as long as you've had your emanage :whistling:

Funny you should mention that. Goes in tomorrow.

Also noticed now that the informeter is back in injectors are at 95%... Fuel reg is going in.

Spoken to the tuner too. Booked out for a month.

So you're booked for 1 months time then? :)

I haven't had my fcon as long as you've had your emanage :whistling:

If you take out the 9 months I was completely without my car, it's probably equal :P

So you're booked for 1 months time then? :)

If you take out the 9 months I was completely without my car, it's probably equal :P

Not booked in, waiting for confirmation from him.

You had 9 months of car off road to install emanage?

You had 9 months of car off road to install emanage?

if only! You can still see my car in the crash repairers yard on google maps :D I cant wait till they update that tile one over summer.

R33 gtr strut brace should fit seeing my 260rs has one fitted from factory! Looks exactly the same as my mates on his gtr

Is anyone able to verify this 100%?

Thinking I'll get the HKS brace for my car, but don't want to spend that much only to find it won't fit...

Alternatively, if anyone has a R33 GTR on the Gold Coast, and was willing to spend a few minutes testing...

Is anyone able to verify this 100%?

Thinking I'll get the HKS brace for my car, but don't want to spend that much only to find it won't fit...

Alternatively, if anyone has a R33 GTR on the Gold Coast, and was willing to spend a few minutes testing...

The strut brace on my 260RS is a spot on match for the one on a mates 33 GTR, I've had his in my engine bay to check this for myself and I'm going to order a 33 brace soon.

Edited by numleg

Put the hdi ebx back on.... Have lost boost on stall launch but when the boost does come on its f$&king scary.

My head down for another tune then out to eastern creek for a run.

Put the hdi ebx back on.... Have lost boost on stall launch but when the boost does come on its f$&king scary.

My head down for another tune then out to eastern creek for a run.

let us know when ya going i wanna see your beast run

rb26stagea, on 16 November 2012 - 02:36 PM, said:

Is anyone able to verify this 100%?

Thinking I'll get the HKS brace for my car, but don't want to spend that much only to find it won't fit...

Alternatively, if anyone has a R33 GTR on the Gold Coast, and was willing to spend a few minutes testing...

The strut brace on my 260RS is a spot on match for the one on a mates 33 GTR, I've had his in my engine bay to check this for myself and I'm going to order a 33 brace soon.

Edited by numleg, Yesterday, 08:14 PM.

Thanks for that; much appreciated!

Its not tunable, but I doubt the afrs will be too far out. No doubt it also still runs a closed loop system, monitoring and self-tuning via the O2 sensor.

The only self tuning the ecu does via the O2 sensor is at idle and cruise. As soon as you put your foot down the O2 sensor has no influence whatever so you really need to know what your afrs are at WOT and a check on the timing would be good as well.

The M35 ecu's definitely seem to self tune to a much higher load than the earlier cars Bob, and anything after 2004 should have a factory wideband sensor allowing the ecu full control of the map + or - 10%.

I agree though, it's a very smart idea to run a separate wideband for safety and nothing beats a tuned standalone if it's available.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah its bad eh. Ey! Watch your mouth. Yep, spot on. The rear's are always gone too though from brake checking. I had them perilously close to a tree that we had taken down. I think the tree peeps may have taken it. Either for a trophy, or accidentally.  
    • f**kin' yikes! That insulation is the shittest stuff I have ever seen. You need to do an insurance job on that f**ker, pronto. WRT to the washer cover, I would have said that there'd have to be some at a wrecker, then remembered that it's a BMW, and reasoned that every single wrecked one would have been tailgating and so the front end would be trashed.
    • Oh and I lost my headlight washer jet cover!
    • Ok, so I got myself some X1 wheels really cheap to try out, they're a bit different and I like them but they're really narrow (18x8) they are available in staggered 18x8/9 also but really hard to find.  I kinda dig them, but not as much as the F10 19's I usually run, so these go into the wheel pile.         As I mentioned in another thread, I got a new exhaust. It's an off-the-shelf stainless one that fits OH-KAY. I don't love the tips size and how far they come out the back, I think I might cut the tips off and replace with some smaller (~3") ones that don't extend as far. It sounds really good though, I'm not sure if its just in my head but the car feels a little quicker, more responsive.      I fitted an eBay special front lip. Surprisingly it fit perfectly and all holes lined up. Its a little rickety but I haven't put any double sided tape on yet, I want to clean the front bar up where it has scraped the road a lot and fil in the number plate holes (or, get body coloured wrap to cover them - is this a thing?  I'm not sure if I'll leave it gloss or pain it matte. I really like it though, I don't particularly like the front bar without it, I don't really like the M-Sport and to get anything else is just too expensive. That said, I might need a new one now anyway as I dropped the car onto the jack after forgetting to put ramps under the front wheels. It bent a lot and while it did go back to normal after I got the car off the jack, I do fear I have not done it any favours.    Lastly, my headlights died. Different problems in each. They have gotten much dimmer over the past year or so, I put new (uber expensive) OSRAM bulbs in them but to no avail. One of them pointed at the ground and the other just kinda did its own thing with light working sometimes. Yeah, check this 18 year old BMW headlight wire. I reckon I know why they were stuffed.            BTW, the yellow and black is the power to the Xenons. Yikes. I hunted around an researched my options here. I would have loved to just get a replacement harness but not a thing. My car has adaptive headlights, that is they rotate left and right with the steering wheel. Good condition used adaptive xenons were over $700 each, non adaptive were around $400 each, but I couldn't help but think that they're all around 18 years old now, surely they'd have the same problems. So I looked at newer LCI headlights but they were even more expensive and I couldn't confirm that they'd be plug and play with lots of people having lots of opinions so not worth the risk.  I ended up getting brand new Chinese headlights from MARS. They're very close to OEM with only the angel eyes being a bit different. I didnt want crazy turn signals or sharp DRL's or anything. Not my bag.  They're not adaptive, I thought thats a feature I wouldn't really miss. So I coded that out.  The lights are awesome, they look so nice and they take so many years off the car. The angel eyes look great and the headlight brightness is ridiculous. I was so used to the old ones, I didn't realise just how bad they were. The new ones use the OEM bulbs, Xenon ballast and leveller motor which I was happier with. The only issue with them is that the rear cover is held on by SEVEN screws. This will be a nightmare to get to and open when I need to change bulbs.   
×
×
  • Create New...