Rolling R32 Gtr Rear Guards

[NSNPWR]

Long story short, had the rear guards rolled on my 32 GTR as just bought some Volks in 18x10+11R+12F.....

The inside lip rolled up perfectly flat to the panel with no cracking but a few small dimples have appeared along the edge, im wondering if anyone else has had this happen when theyve had theirs done? I figured it is because of the shape of the panel as it comes down to the wheel arch, there is a curved edge there factory and perhaps by pushing this out a touch has caused some minor stretching and resultant dimples/indentations.

Just curious to know if anyone else has done it and experienced this.

Edited December 31, 2010 by NSNPWR

[DarrenJC]

Old post....but any chance you have pics of your guards?

[Dan_J]

this mainly happens as the r32 guards have a lil bit or reinforcement behind the guard as you go higher up

[trustr32]

Also you'll find it'll mostly lineup with the spot welds along the seam of that lip that was folded back up. Therefore when rolling them it'll push out more where the spot welds are.