Jump to content
SAU Community

Consult Data

R33shaun

By R33shaun,
in General Maintenance

 Share

Recommended Posts

R33shaun Community Regular

R33shaun

Posted
  • Author
Posted

Works fine, I drove mine around for a few months untuned, it just maxes the afm rather quickly so you don't give it heaps of shit or rev it out. The load of the engine is calculated from the airflow, more flow, more load, different cells.

Mine drove fine for nearly two years with the stock ECU, just couldnt run anymore than stock boost, only downfall is it always ran rich and foulled up plugs quickly

bubba Grand Master

bubba

Posted
Posted

Problem fixed no coughs or splutters at all!

Good work!

Mine drove fine for nearly two years with the stock ECU, just couldnt run anymore than stock boost, only downfall is it always ran rich and foulled up plugs quickly

Mine didn't run that rich. It did on the first drive home because I snapped the RB20 water temp sender and had to use the RB25 item.. resistance was different so the ECU was stuck in coldstart :(

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Ethanol Content Sensor - Always at 11%?

      By GTSBoy · Posted

      You say potato, I say potato?
    • GregosM10
      Carb issues - E15S

      By GregosM10 · Posted

      Based off what you’ve said here, I think I’ve figured out a good bit of what I’ve done wrong -  So on the line going from the PCV valve to carbon canister, there’s a T joint that is pretty much right next to that lower port - I hadn’t noticed that the hose in the diagram was curved to attach onto the carb, so I was putting that line for the lower port onto the PCV line / carbon canister line instead. I’m going to have a flick through the manual again tomorrow and should hopefully find a diagram that’ll show me where that T joint should be connected to. Timing also 100% needs to be sorted out as well, should be able to tackle that tomorrow as well. Definitely feel like I should be on the right track now though. 
    • dbm7
      Carb issues - E15S

      By dbm7 · Posted

      The screw is for idle (pilot circuit) mixture adjustment. Else, I'm confused ~ the diagram shows 2 carby ports, and the intake manifold port, but you're suggesting the "2nd port on the back of the carb that isn’t mentioned in the diagrams" ...yet, both carby ports are shown...que?... ...in any event, that port should be connected, but if not (like it is now), it's unlikely to cause a backfire out the carby (it would introduce false air and give you a fast/lean idle) ...sounds more like timing issues/spark plug wire routing responsible for the backfiring.    
    • MBS206
      Lock up the old for sale / wtb threads.

      By MBS206 · Posted

      That's fair, I can see both points. I get enthusiastic when I see the FS section has a new post and want to see what interesting thing someone is selling. Then I get deflated it's a bump of a 10 year old post. Ha ha
    • MBS206
      Ethanol Content Sensor - Always at 11%?

      By MBS206 · Posted

      Couple of litres of moonshine from his southern cousins would do it...
×
×
  • Create New...