Jump to content
SAU Community

Recommended Posts

just did a quick search and found this

hope it helps

Key cutting is a given-Locksmiths do this for a living. As for the Programming of the NATS key, there are 2 options.

Option 1: Take the key(already cut and ready to go) to your preffered nissan dealership and ask the people there nicely to Program your key to your car, its a 2 min job with a consult system

Option 2: Now this is the tricky bit. It sounds easy and looks easy but its sometimes a pain in the ass if you arent fast enough. There is a simple set of Functions the car can use to recognise you are programming a ke as a secondary option. To do this you will need to:

Here they are....... enjoy!!

ID Code Entry Procedure

To enter the ID code, follow this procedure:

"Setting Mode":

1. Close and lock all doors.

2. Insert and remove the key from the ignition more than six times within 10 seconds. (The hazard warning lamp will flash twice). At this time, the original ID codes are eliminated.

ID Code Entry:

3. Turn ignition key to "ACC" position

4. Push the "lock" button on the new remote control once(for example, if the door is locked using the remote controller during this ID code entry state, a new ID code can be entered). At this time, the new ID code is entered. (The hazard warning lamp will then flash twice).

Additional ID code Entry:

5. If you need to activate additional remote control units, unlock the drivers door, then lock it again(WITH THE DOOR LOCK SWITCH).

6. Push the lock button on the additional remote once.

7. This ID code enable state and setting mode will remain until the drivers door is opened.

NOTE!!

* If you need to activate more than two additional keyless remotes, repeat the procedure "Additional ID code entry" for each new remote.

* If the same ID code that exists in the memory is input, the hazard warning lamps will flash twice but the entry will be ignored.

*Entry of a maximum of four ID codes is allowed and any attempt to enter more will be ignored.

*Any ID codes entered after termination of the "Setting Mode" will not be accepted. Additional keyless remote signals will be inhibited when an ID code has not been entered during the setting mode.

*Some cars that were imported also had a NATS2 system that was varied to the normal Nats. You cant manually program these keys and will need to Take it to a Nissan Dealership to be Programmed with the CONSULT2 system. This may take up to 20 mins and therefore you may be charged a half hour block of labour.

Good Luck and hope this helps!! Might even get a sticky :P

I have only got 1 Key for R34 GTR as well with NATS 2.0

if you do end up doing this and working, can you please let me know

i am getting black key from Japan free soon :)

so need to find a way to do this easily and cheaply

I am pretty sure that procedure is to reprogram the transponder key, not the keyless entry fob...

ps most locksmiths can do a 34 GTR key for about $140 full programmed or do what I did and get a genuine one through just jap and have Nissan Initialise it.

The fob is a different issue.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...