Jump to content
SAU Community

Recommended Posts

Hey guys been helping my brother out with finding a clean R32 GTR. He wants to build one so we are looking for a good base to start from.

As some of you would know this is not an easy task. Have looked at around 12-13 so far in about 8 months...Anyway, long story short we have found a black one that is completely imaculate. No rust at all. Engine wise, interior and body wise... its perfect. Well almost, the only thing is that the car has been involved in what looks to be a minor accident (passenger side rear quarter)The owner has kindly allowed us to put it on a hoist and upon doing so we saw that there is no damage to the chassis rails but there is a slight crisp in the wheel arch which shows that there has been some minor panel beating in the arch itself and it looks as though the guard lip has a little bog on it..The dilehma we have is whether to keep looking or to buy. What do you all think? From experience with R32 GTR's their are many many more bad examples than good ones. The damage is cosmetic not structural and otherwise the car is perfect... 95,000 genuine kms with log books, receipts from japan and Australia.Some advice would be great Ross

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/
Share on other sites

Did you follow this car on a test drive to check if it's crabbing?

Did you look at even/uneven tyre wear?

Do the two doors open evenly without dropping?

Did you check the wheel well to see if it has been crumpled?

Is there any overspray underneath that makes you suspicious?

Is there any bubbling/cracking from underneath or around the bog?

Did the owner allow you to do a robot check with a panelbeater to see if the car is perfectly straight?

If all the above checks out and the test drive creates no concern + the rest of the car is as immaculate as you say it is, I'd buy it (if the price is right)!

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5652455
Share on other sites

Did you follow this car on a test drive to check if it's crabbing?

What exactly is crabbing?

Did you look at even/uneven tyre wear?

Even tyre wear

Do the two doors open evenly without dropping?

Yes

Did you check the wheel well to see if it has been crumpled?

Do you mean like buckled?

Is there any overspray underneath that makes you suspicious?

Well where the crisp is there is a little tar over it, very thin line.

Is there any bubbling/cracking from underneath or around the bog?

Nope

Did the owner allow you to do a robot check with a panelbeater to see if the car is perfectly straight?

No Idea what this is?

If all the above checks out and the test drive creates no concern + the rest of the car is as immaculate as you say it is, I'd buy it (if the price is right)!

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5652501
Share on other sites

I'd check the car a bit further for rust like Chris ^ ^ ^ suggested. Also take a fridge magnet with you.

And tap that thin line of tar with the handle of a screwdriver to make sure you hear the sound of metal.

Crumpled = buckled, yes

When you follow a car, sometimes if you notice that it's like a rectangle that's going slightly sideways rather that straight - or if you can see more of the front fender on one side and not the other, it's "crabbing"

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5652530
Share on other sites

look at the sill panels. are they straight? if not there WILL be rust in the carpet side of them.

Sill panels are good your usual minor surface rust on the ends of the lips on them from a speed bump or what not but the rails and sill panels are all good.

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5652561
Share on other sites

Thanks Terry.

Well car looks good, it has been garaged and usual rust spots are clean so thats good.

I will take your advice with the magnet and the screw driver. As for the crabbing It looks be fine we followed it didn't look unusual, would it be doing it at low speed and high speed?

Wheels look fine also, then again it probably was replaced.

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5652576
Share on other sites

Sill panels are good your usual minor surface rust on the ends of the lips on them from a speed bump or what not but the rails and sill panels are all good.

lay the carpet back - look there. if the sills are grazed they will be wet = rust.

look at my GTS4 thread (see sig) fr more images on what to look for.

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5652878
Share on other sites

It sounds like a pretty good car.

When I bought mine I noticed that a rear guard and a front guard had been resprayed earlier in its life. There are even jig marks on the front rails indicating that there was some earlier repairs. However it all appeared to be done properly panel gaps were perfect and it did / still does drive perfectly. So I snapped it up.

In short these are very old cars now so chances are more than not are likely to have been involved in a prang at some point. But if repaired PROPERLY can continue to be perfect cars.

I remember seeing a pic of former Zoom Magazine editor Julian Edgar's Aussie delivered 32 GTR with a fair bit of rear end damage but I am sure it got fixed properly (as it was the subject of a magazine article at the time)and moved on.

http://autospeed.com/cms/A_0314/article.html

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5653710
Share on other sites

Hey guys been helping my brother out with finding a clean R32 GTR. He wants to build one so we are looking for a good base to start from.

As some of you would know this is not an easy task. Have looked at around 12-13 so far in about 8 months...Anyway, long story short we have found a black one that is completely imaculate. No rust at all. Engine wise, interior and body wise... its perfect. Well almost, the only thing is that the car has been involved in what looks to be a minor accident (passenger side rear quarter)The owner has kindly allowed us to put it on a hoist and upon doing so we saw that there is no damage to the chassis rails but there is a slight crisp in the wheel arch which shows that there has been some minor panel beating in the arch itself and it looks as though the guard lip has a little bog on it..The dilehma we have is whether to keep looking or to buy. What do you all think? From experience with R32 GTR's their are many many more bad examples than good ones. The damage is cosmetic not structural and otherwise the car is perfect... 95,000 genuine kms with log books, receipts from japan and Australia.Some advice would be great Ross

From that description - if it is priced reasonably - buy it.

Link to comment
https://www.sau.com.au/forums/topic/352565-accident-cars/#findComment-5654086
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seemed to be good when Jeff owned it but they did a shit job on my car, probably worth a think before spending 10's of thousands of dollars where they might be cutting corners
    • Starting with issues 1 - 5, we have already run into a problem...!  Issue #4 contained 2x front brake calipers, instead of 1 caliper and 1x steering knuckle. Will have to call DeAgostini on Monday to sort it out. Anyway here's some photos.  Issue #1 is the front bumper, headlights and number plate. Issue #2 is the front wheel (with "We produced with spartan air." text on the centre cap!) and tyre, the front lip spoiler and cylinder head cover with ignition coils under the centre cover... which will never be seen again. Issue #3 is the bonnet and cylinder head. Issue #4 is the front strut, brake disc (with laser etched metal discs) and brake caliper. I stopped here because of the issue with the missing steering knuckle.  Next update will be #5 - #10 in a few weeks.
    • DeAgostini is one of a few companies that release quite large (the largest commonly available size actually) 1/8 scale models in a series of weekly issues over 100 - 110 instalments.  They release different models for different markets and DeAgostini Japan have release the BNR32 Skyline GT-R Nismo last month. I've made two of these 1/8 scale sized cars (one an R35 GT-R from 2012 - 2014, the other I'm just about halfway through, a BNR34 Skyline GT-R from the 2Fast 2Furious movie) so when this R32 was announced there was no way I could ignore it as it's my favourite out of all Nissans.  Each issue costs around $20 so it costs about $2.2K when completed. I suppose it is very expensive for what it is, but the quality and details are really very good, and there are many "gimmicks" like fully functioning exterior and interior lights operated with a remote control, working steering, all doors/bonnet/boot/fuel lid open and close, the side mirrors fold in and it even has a speaker for the engine revving sounds when you turn the lights on.  Each issue comes with a magazine that tells the story of the BNR32 Skyline GT-R Nismo from the first design stages of the BNR32 to Group A homologation and the various racing version that were run in the Japanese Group A and JGTC, and Australian Group A.  So I plan to update the build in this thread 5 issues at a time.  https://deagostini.jp/r32/?srsltid=AfmBOooKjxDc4EUK2rmXqMBPgyHfFJ24s4oEPJBNpnF-lFlsRoW0PE6P
    • As per title.. has anyone used so far? Keen to hear results, comparisons. In the market for a new mani for my new turbo. Any issues cracking?
×
×
  • Create New...