Jump to content
SAU Community

Recommended Posts

The car would of run rich with that split so, not too bad!

In theory under vacuum it would run lean (unmetered air entering), under boost it would run rich (metered air escaping).. the damage done would be the unmetered air which isn't filtered

yeah not exactly a good result. my 32 with stock turbos, stock manifolds, stock injectors, stock cams, stock intercooler, basically 100% standard except for a cat back exhaust, 1 bar boost, and a well tuned power FC ran a 12.4 qtr mile. GET IT TUNED asap. it should be mid to high 11s at this point.

You are far too kind to the beast :D

A few people have run 11.4-11.6 now on stock turbo'd R32GTR's now. Just need to be nasty!

With those turbos you'd be WELL into the 11's, now just high - go for broken greaboxes

were you at the drags last night? I think i saw your car there with the SSR rims?

If so, it did sound a little lumpy too but I also wondered how it wasn't really pulling very fast. Mind you the R35 that was there could only manage around 12 flat anyway so I thought it must have been a slow night.

+1 on the tune then, spend $1k or so on a tune once you get the parts sorted and it'll be worth it...no sense in running it when it's not at optimal settings you could cause damage.

no 1 engine is the same.. you say the ecu is tuned for the turbos.. there is intercooler,exhaust,injectors,headwork,CAMS,and fuel pressure all to bugger it all up.

with those cams it will be way rich down low and super lean up top...

you need to get it dynoed or it will pop.

were you at the drags last night? I think i saw your car there with the SSR rims?

If so, it did sound a little lumpy too but I also wondered how it wasn't really pulling very fast. Mind you the R35 that was there could only manage around 12 flat anyway so I thought it must have been a slow night.

+1 on the tune then, spend $1k or so on a tune once you get the parts sorted and it'll be worth it...no sense in running it when it's not at optimal settings you could cause damage.

Yeh i was there last night. my GTR was the silver one with enkei wheels. There was a white GTR with SSR's and a lumpy cam though. He was getting ok times.

But yeh, Deffinently doing the tune, and im not driving it until i get that done. Today iv Booked it in at Xspeed for next month and they'll adjust the ecu and dial in the cam gears.

Im keeping the cams in. Because Planning for the worst case scenario due to the split pipe. I could have Overspun the turbo bearings. In which case ill chuck in some 2860-5's.

FARK ME youve spent alot of cash having all that done...headwork LOL. No wonder youre bleeding.

So no point telling you it was all for nothing I guess.

But what you do is:

Slap on a stock head, stock cams, stock manifolds, sell all your shiny fuel system bits to cover money wasted and use stock stuff there. Swap the Shitbro pump for a Bosch.

= Much more response and heaps faster 1/4 mile :)

ummm.... how about larger twins? wouldnt that be a better solution to get the most out of my setup????

rather than going stock everything like you said? Id rather not do that after getting all this stuff done...... :unsure:

All I want Is a good balance between response and top end at around 400ps. Which is what I would have thought the -7s and the cams wouldv given me.

Hell no

Larger twins (-5) will just get you more lag and power you cant use because of an unbuilt bottom end

For 400rwhp -7 or -9 is as good as it gets

Edited by Don Dada

ummm.... how about larger twins? wouldnt that be a better solution to get the most out of my setup????

rather than going stock everything like you said? Id rather not do that after getting all this stuff done...... :unsure:

Hey mate, I would not get too stressed about it all just yet. Why don't you see how the tune turns out first and see what they can get out of it with a bit of cam timing adjustment and so on. It may not even have the optimum fuel/ignition tune in it yet.

Once it's got a well rounded tune in it, see what you've got. Then make a decision from there. My guess is its probably got more in it as it stands at the moment - so don't spend $ just yet.

Edited by R32 TT

edit: Hmm just had a quick look. And i found quiet a large split in the intake hose that runs into the intercooler from the turbos.

Which would make sense cos i found i was losing alot of power in the higher rev ranges.

shit...

Iv been driving the car pretty hard all week. hope nothing else have fkd up on it.

sif you didnt get it tuned properly... lucky it didn't pop.... no two cars even with the same setup are 100% with another tune..

  • Like 1

Got it all put in and the tuner did a rough Road tune with the PFC. He did suggest however that i get a dynotune. (but the powerfc i bought was already tuned for those turbos)

Now i just got back from the drags and after doing multiple runs, ran a best time of 13.451 @ 102mph. uughh. wtf?

Can anyone help me out?

a rough road tune, then took it to a track??? well thats one issue

get it on a dyno and get it tuned properly...even if its not faster, its safer and may save you $$$ later

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yuck. But it's kinda the same principle, moving timing around to make car run bad but sound good.... I went for a more spirited tuning drive to iron out a few things. Car no longer stalls, and it loved to dip RPM low when you clutch in. After tuning this (and the 4-5 tables that HPTuners/LS1 OEM ECU wants for idle air correction) it's now behaving somewhat normal. All expected because there's a new TB, new Intake manifold and that new TB which is 102mm vs 78... has an entirely different IAC passage which is smaller because ????? Unfortunately at this point I went to make further fine tuning changes to avoid it flaring up, you know... _tuning_ the HPTuners dongle died. Well to be more accurate - The USB cable died in a fashion that anyone who has ever charged a phone will recognize. After the app demanding I resync it 50 or so times (which all 'succeeded' but all failed) the device does not want to sync and I've logged a ticket with support to see if it's fixable. US Support said it was a 'storage issue' but after removing the SD card inside it and formatting it/fixing it the issue does persist. Unfortunately usually the fix is "Turn in your old dongle and pay $700 for the upgraded one" it's cheaper because I get some free licence credits I unfortunately don't need. However I'm 10 minutes down the road from HP Tuners AUS/VCM so at least I won't need to post it, and logged a new ticket for support over here. Definitely drives different. My SOTP dyno believes it's probably making 310-320kw instead of the 280 before.  It scrambles for traction a little now whereas it previously different. It drives like a bigger cam car up top even though the cam is smaller, likely due to the cam not being advanced 6 degrees. The timing is deliberately low and the fuel is very rich so who knows if this will improve on the dyno. It may, imperceptably. Also funny is removing the pineapples definitely makes the car squat more and axle tramp less. So this behavior of having more top end, squatting more, and scrabbling for traction more makes me think = more power. But I could have just been sitting on the threshold of that kind of behavior before. Time will tell if my butt dyno is calibrated right. I need the exhaust leaks fixed before dyno tune for obvious AFR related reasons - I repositioned the pipes but I'm not confident it's fully sealed even if it is better. At least the car does drive around while I cannot tweak/tune it for now. And I have aircon again. medium success!
    • Don't use that manifold. Please don't use that manifold. Sunk cost fallacy is not worth the later pain. None of these will be relevant to the change that will come from the different turbo and manifold. As in, the effect of the exhaust will be nil, regardless of what else is changed. And all the cam and fuel system stuff is not changing either way, so has no effect. The turbo and manifold (and to a small extent the wastegate)....big change.
    • Just wanted to say thank you for your input   my man (lead mechanic by trade) and I have done a heap of work as you can imagine just to make the hot side work with the dump pipe, stupid massive intake on turbo, trying to get the waste gate on was not fun.  I’m kinda getting to the point where I don’t know if I try and make this work and not throw all this cash and time away or do I scrap the lot and start again? the Apexi I’ve got was tuned for a few slight differences:   Tomei pon cams (mine are stock neo) Turbo smart 38mm external waste gate (mines 45mm replumbed) with stainless screamer pipe  3inch turbo back exhaust with high flow cat Sard 800cc top feed injectors Sard adjustable fuel pressure reg    
    • Out here E90s are the cheapest way into a sporty-ish car because everyone knows just how expensive the repairs can get. 8-10k USD for an automatic 335i. 
×
×
  • Create New...