Jump to content
SAU Community

For Sale Thread


Cubes

Recommended Posts

I have a number of R34 parts for sale:

  1. R34 3-gauge cluster - perfect condition $80
  2. R34 3-gauge surround - pretty good condition, minor wear to the R34 interior paint $100
  3. R34 Orange Front Indicators - perfect condition $20
  4. R34 Manual Gear Surround & Ashtray - as above with 3-gauge surround, some marks/wear to R34 interior paint $75
  5. Nismo 3-gauge cluster - perfect condition, used for a short time before fitting GTR MFD - in original box$250

I've just checked nengun, and the nismo 3-gauge clusters are now discontinued - so here's a good opportunity to pick one up.

I've searched around the forums, and these prices seem pretty spot on what others are selling them for.

Happy to post - send me a message for me to contact postoffice and get a quote on postage.

Pictures of items:

nissan%20triple%20meter.jpg

nissan%20triple%20meter%20cover.jpg

nissan%20front%20indicators.jpg

nissan%20gear%20surround%20ashtray.jpg

nismo%20triple%20meter.jpg

Link to comment
Share on other sites

Fs rb20det engine with intake and exaust manifold complete engine and trans with new yellow jackets $1400 no blow bye doesnt smoke serviced reguarly with hpr 15 penrite need this gorne make offers and come take it out

Link to comment
Share on other sites

A few things i have for sale that are no longer needed.

Firstly is a Blitz active type clutch which is a twin plate clutch built by ORC for Blitz.

It can be used as a single or twin plate and is one of the only clutches to be able to do so.

I have had it in my car for the last three years and it has done under 5000km of City driving it has never been tracked.

I am asking $2000 ono as it cost me $3000 when i bought it.

It comes with clutch, bearing carrier, thrust bearing and flywheel bolts.

My loss is your gain as i only found out about this being able to be made into a single type clutch after i had already installed the new NPC clutch.

R34 GTT front and rear rotors and Hawk Pads(Unknown type as cam with car) - $300ono

10inch subs - $50 each ono

Link to comment
Share on other sites

OK I still have some Clipsal tickets for sale ....

1 x 4 day Pit Entry Gold $195

1 x Saturday Pit Entry gold ticket $85 (general admission price at the gate)

1 x Sunday Pit Entry gold ticket $88 (general admission price at the gate)

Obviously these are premium Gold tickets in a great position, with a giant TV screen opposite, are undercover, and you have access to all the Gold areas!

Link to comment
Share on other sites

for sale

a pair of weather shields suit r33 good condition come with all clips

$60.00

cheers dean

Hey man Intrested in them were abouts u located

Msg or call me on 0422 102 617

Cheers mark

Link to comment
Share on other sites

OK I still have some Clipsal tickets for sale ....

1 x 4 day Pit Entry Gold $195

1 x Saturday Pit Entry gold ticket $85 (general admission price at the gate)

1 x Sunday Pit Entry gold ticket $88 (general admission price at the gate)

Obviously these are premium Gold tickets in a great position, with a giant TV screen opposite, are undercover, and you have access to all the Gold areas!

no good for me, but have a mate possible keen on the weekend pass. Will let you know tomorrow.

Link to comment
Share on other sites

gotta get rid of these stuff come and take it!

R33 GTR spoiler fibreglass ; $120

R33 GTST Blitz nur spec exhaust ; $250

or the whole lot for $350

photos can be seen

>> click photos

contact ; 0411166292 ask for Peter

Cheers

Edited by rawr.
Link to comment
Share on other sites

>>>> HKS EVC 5 <<<<

got this in my car but im gonna go back to adjustable actuator

LCD doesn't light up but i think its because i haven't wired the power for it up correctly

comes with everything you need to have it running

$400 or swap for other after market electronics

pic:

http://i53.tinypic.com/alizpl.jpg

pmed

Edited by rawr.
Link to comment
Share on other sites

Bumpn

Wrecking T-Boned R33 :( Everything good on passenger side, Everything on drivers side is toast.

RB25 DET Complete Motor = KM's: 97,000Kms

Condition: Excellent, No leaks, serviced every 5,000Kms.

Turbo Auto Transmission - Serviced at 65,000Kms. Great Condition

High Flow R33 Turbo - Fresh Rebuild Only Done 15,000Kms max

Auto/Manual Turbo ECU with Loom

Front Rotas & Calipers, Brake Booster etc.

Reason For Sale: Was T-Boned By A Blind Bat

Also comes with EVERYTHING you would need, bolt it in and off you go. E.g. Alternator, Powersteer Pump, Injectors, Injector Rail, Exaust Manifold, Coil Packs etc etc etc - All complete.

Will take $3400 for EVERYTHING, open to offers. - NEW price

Will seperate if cannot find a buyer for the lot,

Please email: [email protected] or phone 04500 43974

Keen on turbo how much

Link to comment
Share on other sites

Trust MX front pipe for RB26DETT.

Dent in the usual spot from a previous owner, was still flowing perfectly. Only replaced due to going to the Greddy dump/ front pipe extension.

Take it away for $100 ono

EDIT: Also have standard 32 GT-R manifolds.

Perfect if you are doing a turbo swap, get these port matched before you start then just swap them over with your old ones!

$100 also

Link to comment
Share on other sites

Hi guys.

I've got a S2 rb25det 133,xxxkm bare engine suiting rebuild for sale $550.

Also a full brand new unopened VRS gasket kit that will include for an extra $400, this kit has FULL gaskets for intake manifold, head gasket, head seals, exhaust manifold, turbo gaskets (dump etc) and retails for over $500.

Please PM any enquiries.

Link to comment
Share on other sites

FOR SALE

R32 GT-R WHEELS WITH CENTRE CAPS

Tyres Also..

Full Set of R32 GT-R standard rims, centre caps included (1 cap has 8-10mm scratch on face)

General condition of all four rims are above average, some understandable gutter rash on front left, all other rims only have very minor areas around the outer edge of rim that are flaked away.

Tyres also barely worn, Kuhmo Ecsta SPT 205/45/16 on front set and 225/45/16 on rear set. The previous owner of these rims ran them on his street driven Toyota MR2, therefore explaining the differences in tyre width. Altogether, I would say the tyres themselves still have absolute minimum 85% wear.

'

These rims have never been on my R32 and I purchased them for track days but I have decided against putting it on the track and am now exploring other avenues.

Asking $750

Anyway it's just a set of wheels so I wont babble on, I have pics ready to email PM if interested

Alternatively, give me a call or text on 0457408477

post-79191-0-77966300-1300427365_thumb.jpg

Link to comment
Share on other sites

Hey all got my Wheels up for sale

17x8 and 17x9 Enkies .. unknown offset, guessing around +35/38 ish

with... good tyres with around 65-70% ...

PCD; 5x114.3

Price; $500

Contact; 0411166292

will not post interstate looking for local sale only

cheerio..

post-83684-0-00492100-1300466793_thumb.jpg

post-83684-0-83526200-1300466811_thumb.jpg

Link to comment
Share on other sites

Hi guys.

I've got a S2 rb25det 133,xxxkm bare engine suiting rebuild for sale $550.

Also a full brand new unopened VRS gasket kit that will include for an extra $400, this kit has FULL gaskets for intake manifold, head gasket, head seals, exhaust manifold, turbo gaskets (dump etc) and retails for over $500.

Please PM any enquiries.

I've put a full description and pics in its own thread here:

http://www.skylinesaustralia.com/forums/topic/357959-sa-rb25det-suit-rebuild-full-vrs-kit/

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Much less twat-tastic. CF wheels are too garish for civilised use.
    • From there, as the manual says....assembly is the reverse of disassembly, no tricks worth mentioning Much better (for me)
    • In my case, the standard wheel I had was in good condition but the buttons had more wear, so I swapped them across from the original wheel from the car. The plastic rear cover is held on by 4 tabs, and once the wiring is removed you can get access to 2 screws on each side the hold the buttons in From there I just swapped the wiring over. What was interesting is the standard style wheel is 2.0kg but the carbon fibre one is 50% heavier at 2.9kg. It even has a weight inside the wheel at the top to make up for some sort of imbalance in the design. weird
    • Once the airbag is off, to remove the steering wheel.... Undo the 2 plugs into the clock spring, and the horn connector from it's clip. Hit the 19mm nut with a rattle gun (preferably) or if you don't' have one, you probably want an assistant to hold the wheel in place while you use a breaker bar to undo the nut Then, screw the nut back on 3 turns, and pull the wheel sharply towards you. If that doesn't work hit it medium force with a rubber mallet on either side, or possible behind if you can get there. If that all fails (it shouldn't!) you might need a steering wheel puller
    • So, to next task....the carbon fibre steering wheel was either an expensive factory option or a chinesium special. Either way, I don't like either the flat bottom or thick ring style, so it had to go So...to remove the steering wheel.... First, disconnect battery negative and stomp on the brake pedal for a few seconds. Then, remove the small circular covers on each side of the wheel's rear surround to uncover the airbag clips. You need to push something like a flat bladed screw driver through, to push the steel clip inwards and pull the side of the airbag forward. Once you've done the easy side, same on the centre console side. You can see the tab you are shooting for circled in red Then, disconnect the horn spade connector and for the yellow airbag plug you need to get something small under the black locking tab to pop it out, then the connector releases......airbag is off  
×
×
  • Create New...