Jump to content
SAU Community

95 R33 Gts25T Skyline For Sale

NikhtaR33
 Share

Recommended Posts

NikhtaR33 Contributor

NikhtaR33

Posted
Posted

hi just selling my 1995 R33 Gts25t series 1 in white colour..Owned the car for just over 6 months never had a problem with it...Selling due to travelling to tafe and uni is too far for me to drive in a skyline 4 days a week...

The car has 114,000km's on it...at 110,000 i had a major service done..including timing belt, water pump, all drive belts, oil, oil filter, coolant flush etc... all running perfectly except one of the belts whistles when it first starts up (needs to be tightened). The car had new disck brakes and pads put on it at 105,000kms and also at the same time was taken to matouks racing for a re tune. The car makes 210kw atw at 10psi (driven on 7psi mostly).

The car has a full 3" "inch exhaust system, k&n pod filter, front mount intercooler, Blitz dual stage boost controller, and the re tuned ecu by matouks racing.

Interior condition is immaculate!

Exterior has usual light scrathes marks but very good considering the age of the car..

Selling for $8,500 NON NEGOTIABLE! dropped it down from $11,000 as a buyer fell through at $10,000 due to a loan issue.

I bought the car late 2010 for $10,000 and have spent just over $1,500 on it so it owes me a bit..However 8,500 is a loss that i can handle...my loss is ur gain...

contact me anytime, call or msg

Nikita

0433 793 100

Link to comment
https://www.sau.com.au/forums/topic/354260-95-r33-gts25t-skyline-for-sale/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      Mistakes were made, my R34 Story

      By Kinkstaah · Posted

      The cam I am actually putting in (a few posts up) is actually smaller than my current one. At least duration/overlap wise. All the chop stuff I hear just sounds like an engine running badly, because it is. I then envision driving it around in 1st gear and being massively sad about it bucking to the beat of said chop. There is an idle video of someone with a similar cam floating around the internet, but mine is a custom cam (so is his) so it'll never be the same, plus the fact exhausts are entirely different. What I want to do is put some bullet mufflers/race mufflers in to replace a couple sections straight pipes that currently replace the two extra cats that I don't need. But this is even further down the line!
    • MBS206
      Shoota's R33 GT-R RB30/26

      By MBS206 · Posted

      I can tell you now, when the bracket that the little hydraulic ram attaches to snaps, with a subframe, and V8 from an AMG C63 on it, it sounds like someone letting shotgun off right beside you. It leaves your ears ringing, and a huge thankfulness that you never ever put a body part under something heavy that's only supported by a hydraulic lift...
    • Neostead2000
      Water leaking into the rear trunk

      By Neostead2000 · Posted

      Still not a guarantee fix. I used a high quality butyl-mastiq (the black goo that's not really silicone nor polyurethane, same stuff they use from the factory that just spreads out like melty cheese), and I still get lots of water on both sides of the trunk when raining or washing the car. I also suspect the factory spoiler rubber gasket might not be sealing well, so I'm thinking of adding a thin layer of grey silicone around the bolt holes on both sides and see if that's where it also leaks from. The biggest issue is that these cars don't come with a drain hole on each side like other coupes and hatchbacks.
    • Ozdavroz
      Lifted R32? Jay (LowStandards) has you covered.

      By Ozdavroz · Posted

      I hate it, but maybe he could paint it Monster jam style and call it...godzilla?
    • GTSBoy
      WTB-R32 gtst front bar-sydney

      By GTSBoy · Posted

      Would seem to me to be appropriate to go GTR style bar. There are options with and without N1 vent holes, with the GTR lower lip integral (because FG copy). https://justjap.com/search?q=r32 bumper  
×
×
  • Create New...