Jump to content
SAU Community

Does Any One Know Somthing About My Problem


Recommended Posts

Hi

i have a 1996 r33 series 2 Gts-t and i have had some problems with it after i had the following dump/front pipe and a tune done by a workshop. I took my car out and after hitting high revs then backing off the accelerator suddenly my cars idle droppes below 500 and fluctuated and the engine shakes and It seems that my car is using more fuel then it used to HELP!!!!.

So i tried to see if i could fix the problem. .. I changed to a high flow fuel pump, changed the fuel filter,installed yellow jacket coils and plugs and air flow meter was changed and even the ecu was changed but still same problem.. after all this i took my car to a skyline mechanic and he still could not find the problem :angry: can someone please help me I've spend nearly thousands of dollars trying to sort this problem out but it seems its a mystery

BTW the car runs Ok at low revs but once you hit high revs the car begins to play up.

Mods

FMIC

Full Turbo Exhaust System

High Flow Fuel Pump

Standard Ecu

Yellow Coil Pack

Boost Controller (10psi)

Cheers

Edited by fly333

How could they tune your ecu if its standard? Unless you have the Nistune board added to it.

As for your problem it could be: Worn CAS, Air leaks on intake side.

Can't really think of anything else at the moment.

you are probably seeing over 10psi and going into rich and retard mode.

your ecu will be retarding the timing majorly as the stock setup is not designed to take 10+psi

some cars do it at 10psi, some at 12, etc etc

but it's always around 10

try dropping the boost and seeing what happens

also what kind of a "tune" did the workshop say they gave you with a stock ecu?

My question is, if the car start exhibiting these symptoms after you modified it...why on earth did you go replacing everything else in the engine bay instead of checking what you just changed about the engine? Should have taken it straight back.

Could be the wastegate not opening up enough = R&R mode. If it's one of those el cheapo split pipe dumps, welcome to the world of rich and retard. Disconnect the actuator arm from the wastegate periscope and see how much movement there is for the flap...it should be able to open a full 90 degrees, if not more.

  • 1 month later...

You would have to be a retard to rebuild the whole engine when it may have been an electrical fault and spending thousands rebuilding the engine may not solve the problem.

If you want to do the throw-money-at-it-until-the-problem-goes-away solution, buy a half cut or a long motor for $1500 and transplant everything.

i suggest calling my friend henry and see him about it he helped me heaps with my car say i sent you, Bruno, Cosmic performance 0422 117 168

if not try to change 02sensor 120 at BURSONS its located near your turbo kind of sparkplug sticking out looking thingy lol, if not goto this guy he may help you

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That may not be so tricky with a changeover relay (again, with LED indicator only to reduce load on existing headlight + source)  30 to indicator + globe side 86 and 87 to headlight parker + 87a to original indicator + chassis side 85 to chassis/earth repeat on each corner, sorted, no diode required
    • There might have been some "hard core" decalcification going on in the cells to create that noise As for chargers, I stick all our cars on a trickle charger every few months to "clean out their pipes/cells", the Mrs battery in her Mistsu ASX is still running its OEM from new battery 10 years on, and that thing does alot of short drives, and it can sit around for ages without a good long run
    • I'm not sure the diode only will give the desired result. I'd probably approach it with a couple of relays (And you still might need a diode too!). You need to be able to break the constant feed from the headlight to the orange corner globe when the indicator is flashing. Not knowing which Skyline we're talking about specifically here too (And it may not matter, but I don't know the R34 column switches) you'd likely need to rewire the stalk, so that the indicator power itself no longer runs through the stalk too, as now you need it able to trigger a relay that will break the constant supply from the headlights to the indicator, then you'll need a separate relay to trigger the indicators to come on (Replacing the internal action of the indicator stalk).
    • Weird story from me My Toyota 86 was with Commbank comprehensive but for market value (who they use to underwrite is unknown) When I munted it beyond financially viable repair in 2020, rear end smashed in to the point it bent the rear quarter and roof, they knew I paid $31k cash for it because I told them, they still paid me out $38k, as all the 2017 limited edition variants with typical Km and condition were going for between $36-41k, so they did weird math and came up with $38k I never officially mentioned any of the mods that I had done, but as they were not the cause of the crash they were not fussed at all, the insurance inspector actually asked if I wanted to replace all the mods with the OEM stuff if I still had it laying around before they took the car I still came out of it behind though, because I had probably dropped $20k in it with the suspension (bent after the prang), wheels (bent as well) and "other" mods, that the inspector asked about But still, as the market value was higher than what I initially paid, and they paid out market value To say I was surprised with the outcome would be an understatement  Weird, but true, but probably just lucky with the inspector on the day I guess  Sadly, I don't think if I munted the old NC1 MX5 I would get the same result Meh, pay to play
    • Well, the car is back, all straight and shiny, for how long for is anyone's guess  After picking it up we went for a bit of a drive, Jebus I really enjoy driving this little thing, hopefully the weather let's us go for a nice long cruise this weekend as it will be out of my hands for at least a few days next week when it heads back into Mania on Monday It's weird, whilst I do always enjoy going for a drive, the NC makes me feel like a kid who has just got his first car, and they just want to drive wherever and whenever they can I really need to look into the MX5 Club of NSW
×
×
  • Create New...